CAME ZL90 Installation manual - page 9
./
.#
#
&53)"),% !
48
48
48 #
.#
%
0
#8 #9 43
%
0
#8 #9 43
%
0
#8 #9 43
(DOC)
(DIR)
Pa
g.
9
- M
an
u
al
c
od
e:
3
1
9
U
1
6
31
9
U
16
ve
r.
1
.0
1.
0
1
1/
2
0
11 © C
A
M
E c
an
ce
lli auto
m
ati
ci
s.p.a. - T
h
e d
ata a
n
d i
nf
or
m
ati
on
r
ep
orte
d i
n th
is
in
stall
ati
on m
an
u
al a
re s
u
sc
ep
tib
le to
c
h
an
g
e at a
ny tim
e a
n
d with
ou
t o
b
lig
ati
on
o
n C
A
M
E c
an
ce
lli auto
m
ati
ci
s.p.a. to n
otify u
se
rs.
ENGLISH
At each opening and closing command, the control board
assesses the effi ciency status of the control devices (photocells). Any anomaly
found is signalled with the fl ashing of the (PROG) LED on the control panel.
Consequently it cancels any commands coming from the remote control or the
button.
Electrical connection to enable the photocell safety test:
- the transmitter and the receiver, must be connected as per the diagram;
- set DIP switch 8 to ON to activate test operation.
IMPORTANT:
when running the safety test function, the N.C. contacts, if unused, should be excluded on the relative DIP switches (see chapter
7 “selecting functions”).
6.8 - ELECTRICAL CONNECTION FOR THE PHOTOCELLS FUNCTIONS TEST
Stop button (N.C. socket)
- Button to stop gate while excluding the automatic closing cycle. For
movement to resume you must press the command button or transmitter
button.
Key selector and/or opening button (N.O. socket)
- Gate opening command.
Key selector and/or commands button ()
- Gate closing and opening contacts, by pressing the button or
turning the selector key, the gate movement is inverted or halted
depending on which selection was just made. (see selecting
functions, dips 2 and 3).
Key selector and/or partial opening button (N.O. socket)
- Opening of one gate leaf to allow pedestrian passage.
Key selector and/or closing button (N.O. contact)
- gate closing command.
6.7 - COMMAND DEVICES