Cameo CLFLOWERHP User Manual - page 8
CONNECTIONS, CONTROLS AND INDICATORS
:
LED DISPLAY
The four digit LED display indicates the operating mode and other system information.
CONTROL BUTTONS
MODE: Selecting the different operating modes.
ENTER: Confirming program selection and value changes.
UP and DOWN: Selecting a program, changing the program speed and DMX address.
DMX IN
3-pin male XLR socket for connection of a DMX controller (e.g., DMX mixer).
DMX OUT
3-pin XLR socket for looping through the DMX control signal.
POWER IN
IEC power socket with built-in fuse holder. Connection via the included IEC power cord.
IMPORTANT INFORMATION:
Replace the fuse only with a fuse of the same type and rating. If the fuse blows
repeatedly, please contact an authorised service centre.
POWER OUT
IEC mains output socket. Used to supply power to additional CAMEO projectors. Make sure that the total cur-
rent consumption in amperes (A) of all connected devices does not exceed the specified value on the device.
1
2
3
4
5
6
8
9
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ESP
AÑOL
POLSKI
IT
ALIANO