Cameo CLLWOOKIE150G WOOKIE SERIES User Manual - page 19
19
OPERATION / BEDIENUNG / UTILISATION / OPERACIÓN / OBSŁUGA / UTILIZZO
EN
A few seconds after connecting to the power supply, the laser is ready for operation and the operating mode that was previously selected is
activated.
9-CHANNEL DMX-CONTROL AND SETTING THE DMX START ADDRESS
Press the MODE button repeatedly until “d” and the DMX start address appear on the display (d001 - d512). The DMX start address can now be
adjusted as desired by using the UP and DOWN buttons. To save, press ENTER. As confirmation, the word “SAVE” appears for a short time on the
display. The synchronous control of multiple lasers (same model) through a DMX control unit (e.g. DMX mixer) can be achieved by assigning the
spotlights to an identical DMX start address and connecting them using DMX cables.
3-CHANNEL DMX-CONTROL AND SETTING THE DMX START ADDRESS
Press the MODE button repeatedly until “A” and the DMX start address appear on the display (A001 - A512). The DMX start address can now be
adjusted as desired by using the UP and DOWN buttons. To save, press ENTER. As confirmation, the word “SAVE” appears for a short time on the
display. The synchronous control of multiple lasers (same model) through a DMX control unit (e.g. DMX mixer) can be achieved by assigning the
spotlights to an identical DMX start address and connecting them using DMX cables.
SLAVE MODE
Press the MODE button repeatedly until “SLAV” appears on the display. To save, press ENTER. As confirmation, the word “SAVE” appears for a short
time on the display. Once the slave unit has been connected to the master unit (same model) using a DMX cable (Master = DMX OUT, Slave = DMX
IN), and the master unit has been set to one of the standalone modes (automatic control or music control), the slave unit follows the master unit.
TEST MODE
The test mode offers the possibility to activate one of the 32 available projection patterns (t001 - t032). Press the MODE button repeatedly until
“tESt” appears on the display, select the desired pattern using the UP and DOWN buttons and save the entry by pressing ENTER. As confirmation, the
word “SAVE” appears for a short time on the display.
COLOUR SELECTION (ONLY FOR MODELS WOOKIE200RGY AND WOOKIE400RGB)
Press the MODE button repeatedly until “COL_” appears on the display, select the desired colour for the projected patterns (WOOKIE200RGY COL1
- COL4, WOOKIE400RGB COL1 - COL7) using the UP and DOWN buttons and save the entry by pressing ENTER. As confirmation, the word “SAVE”
appears for a short time on the display.
AUTO MODE
The Auto mode combines different projection patterns, rotates them and varies the size of the projection. Press the MODE button repeatedly until
“Auto” appears on the display and save the entry by pressing ENTER. As confirmation, the word “SAVE” appears for a short time on the display.
MUSIC CONTROL
Press the MODE button repeatedly until “Soud” appears on the display and save the entry by pressing ENTER. As confirmation, the word “SAVE” ap-
pears for a short time on the display. Now the laser is controlled by the built-in microphone and follows the beat of the music (bass pulses). To adjust
the sensitivity with which the projector reacts to music signals (bass pulses), use the SENSITIVITY controller. When turned to the left, the sensitivity is
lowered, when turned to the right, it is increased.