Cameo CLMHRGB60W User Manual - Operation:

oPeRaTion:

aUTo mode

Press the MODE button ("Addr" will appear in the display) and then use the 

UP and DOWN buttons to select the Auto mode ("AUTO" will appear in the 

display). Now press the ENTER button and use the UP button to select the 

Master mode (MAST) or DOWN to select the Stand-alone mode (ALON) and 

confirm with ENTER. The display will now read "AU-M" for Master mode or 

"AU-A" for Stand-alone mode.

In Master mode, additional lights of the same type can be used as slave 

units on the master unit. Select the DMX mode for the slave unit and set the 

DMX start address to 001. Using a DMX cable, connect the slave unit(s) to 

the master unit (master unit DMX OUT - slave-unit DMX IN). Now the slave 

unit follows the master unit.

In stand-alone mode, the light operates independently of any other units 

connected to it. 

ShoW mode

Press the MODE button ("Addr" will appear in the display) and then use the 

UP and DOWN buttons to select the Show mode ("SHOW" will appear in the 

display). Now press the ENTER button and use the UP button to select Show 

1 (SH-1) or DOWN to select Show 2 (SH-2) and confirm with ENTER. Show 1 

and Show 2 contain pre-programmed sequences of motion and colour and 

gobo changes.

ReveRSe Pan

This function makes it possible to reverse the PAN motion.

Press the MODE button  and then use the UP and DOWN buttons to select 

the Reverse Pan function ("r PAN" will appear in the display). Now press the 

ENTER button and use the UP button to select Reverse On (ON) or DOWN to 

select Reverse Off (OFF).

Confirm with ENTER.

8

9

IT

ALIANO

POLSKI

ESP

AÑOL

FRANCAIS

FRANCAIS

FRANCAIS

FRANCAIS

FRANCAIS

DEUTSCH

ENGLISH