Cameo CLPFLATPRO12 User Manual - page 21
21
COLOUR MACROS
In this mode, one of the 5 basic colours of the projector or one of the 10 different mixed colours can be selected as a preset.
Press the MODE button until “MACRO” appears in the upper line of the display. Now press ENTER and then select one of the 15 colour presets using
the UP and DOWN buttons. Confirm with ENTER.
MACRO 01 = red
MACRO 09 = pink
MACRO 02 = green
MACRO 10 = light green
MACRO 03 = blue
MACRO 11 = magenta
MACRO 04 = white
MACRO 12 = turquoise
MACRO 05 = amber
MACRO 13 = orange
MACRO 06 = yellow
MACRO 14 = cool white
MACRO 07 = cyan
MACRO 15 = warm white
MACRO 08 = lavender
COLOUR CHANGE
In the colour change mode (jumping mode), 13 different colours alternate in rapid succession (red, green, blue, white, amber, yellow, cyan, lavender,
pink, light green, magenta, turquoise, orange). The speed of the program is adjustable separately and a stroboscope effect can also be activated.
Press the MODE button until „JUMPING“ appears in the upper line of the display. Now, press ENTER until the cursor appears in the lower line of the
display, and then select the rate (SPEED) using the UP and DOWN buttons, with the colours alternating from 00 to 99.
Confirm with ENTER. The indicator in the bottom line of the display changes to „FLASH:xx“. The cursor will appear in the bottom line at the same
time and you can activate the stroboscope effect using the UP and DOWN buttons and adjust the flash frequency from 00 to 99 (FLASH:00 = strobe
deactivated, FLASH: 01 = approx. 1 Hz, FLASH: 99 = approx. 20 Hz). Confirm with ENTER.
COLOUR
CHANGE
STROBOSCOPE
Rate SPEED:00 - SPEED:99
Flash frequency FLASH:00 - FLASH:99
COLOUR BLENDING
In the colour fade mode (fading mode) different colours are blended into one another in succession. The speed of the program is adjustable
separately and a stroboscope effect can also be activated.
Press the MODE button until “FADING” appears in the upper line of the display. Now, press ENTER until the cursor appears in the lower line of
the display, and then select the rate (SPEED) using the UP and DOWN buttons, with the colours alternating from 00 to 99.
Confirm with ENTER. The indicator in the bottom line of the display changes to “FLASH:xx”. The cursor will appear in the bottom line at
the same time and you can activate the stroboscope effect using the UP and DOWN buttons and adjust the flash frequency from 00 to 99
(FLASH:00 = strobe deactivated, FLASH: 01 = approx. 1 Hz, FLASH: 99 = approx. 20 Hz). Confirm with ENTER.
COLOUR
BLENDING
STROBOSCOPE
Rate SPEED:00 - SPEED:99
Flash frequency FLASH:00 - FLASH:99
AUTO MODE
Press the MODE button repeatedly until „AUTO MODE“ appears on the display. In this operating mode, the light switches automatically between
colour change and colour blending mode. The colour change and/or colour blending rate is determined by the settings of the respective mode. A
stroboscopic effect cannot be activated.