Cameo CLTWINSCAN20 User Manual - page 14

Manual is about: DUAL GOBO SCANNER WITH 2 X 10W CREE LEDS

Page of 40

Download

Bookmark us

OPERATION / BEDIENUNG / UTILISATION / OPERACIÓN / OBSŁUGA / UTILIZZO

A few seconds after connecting to the power supply, the effects projector is ready for operation and the operating mode that was previously

selected is activated.

ADJUSTING THE OPERATING MODE

Press the MODE button repeatedly until “MOde” appears on the display and save the entry by pressing ENTER. Using the UP and DOWN buttons,

select the desired operating mode and confirm with ENTER.

DMX modes 1-channel, 3-channel, 4-channel, 8-channel (You will find tables with the channels of the different DMX modes on the following

pages of this user’s manual):

SLAVE mode

Once the slave unit has been connected to the master unit (same model) using a DMX cable (Master = DMX OUT, Slave = DMX IN), and the master

unit has been set to one of the standalone modes (automatic control or music control), the slave unit follows the master unit.

AUTO mode

Once you have selected the AUTO mode and confirmed the selection by pressing ENTER, the automatic program currently enabled will show on the

display (AUt1 - AUt9). Press ENTER again and select one of the 9 different programs (digits flash, select using the UP and DOWN buttons and confirm

with ENTER). To adjust the running speed of the activated program (SP00 - SP99), press once on UP or DOWN, then on ENTER and select the speed

using the UP and DOWN buttons (SP00 = minimum speed, SP99 = maximum speed). Confirm with ENTER.

Music control mode

Once you have selected the Music control mode and confirmed the selection by pressing ENTER, the program currently enabled will show on the dis-

play (SOU1 - SOU9). Press ENTER again and select one of the 9 different programs (digits flash, select using the UP and DOWN buttons and confirm

with ENTER). To adjust the microphone sensitivity (Se00 - Se99), press once on UP or DOWN, then on ENTER and select the sensitivity using the UP

and DOWN buttons (Se00 = minimum sensitivity, Se99 = maximum sensitivity). Confirm with ENTER.

ADJUSTING THE DMX START ADDRESS

Press the MODE button repeatedly until “Addr” appears on the display and confirm by pressing ENTER. While the characters are flashing on the

display, the DMX start address can be set as desired using the UP and DOWN buttons (A001 - A512). To confirm, press ENTER. The synchronous

control of multiple lasers (same model) through a DMX control unit (e.g. DMX mixer) can be achieved by assigning the spotlights to an identical DMX

start address and connecting them using DMX cables.

SYSTEM SETTINGS

To adjust the system settings, reset settings, initialise the engine and query system data, press the MODE button repeatedly until “Sett” appears on

the display and confirm by pressing ENTER. Using the UP and DOWN buttons, select the desired menu items in the system settings and confirm with

ENTER.

The menu items and their functions are shown in the table below: