Cameo FLAT MOON User Manual - Installation And Mounting

IT

ALIANO

POLSKI

ESP

AÑOL

FRANCAIS

DEUTSCH

ENGLISH

11

DMX

A

INSTALLATION AND MOUNTING

Thanks to its integrated double bracket, the lamp can be positioned in a suitable location on a level surface. Installation 

on a traverse is possible with a suitable traverse clamp (not supplied). Ensure

secure connection to the mounting bracket and secure the lamp at the securing eyelet (A) with a suitable safety cable. 

Important: Overhead installation must only be carried out by qualified personnel.

DMX TECHNOLOGY

DMX-512

DMX (Digital Multiplex) is the designation for a universal transmission protocol for 

communications between corresponding devices and controllers. A DMX controller sends 

DMX data to the connected DMX device(s). The DMX data is always transmitted as a serial 

data stream that is forwarded from one connected device to the next via the "DMX IN" and 

"DMX OUT" connectors (XLR plug-type connectors) that are found on every DMX-capable 

device, provided the maximum number of devices does not exceed 32 units. The last device 

in the chain needs to be equipped with a terminator (terminating resistor).

DMX CONNECTION

DMX is the common "language" via which a very wide range of types and models of equipment from various manufacturers can 

be connected with one another and controlled via a central controller, provided that all of the devices and the controller are DMX 

compatible. For optimum data transmission, it is necessary to keep the connecting cables between the individual devices as short as 

possible. The order in which the devices are integrated in the DMX network has no influence on the addresses. Thus the device with 

the DMX address 1 can be located at any position in the (serial) DMX chain: at the beginning, at the end or somewhere in the middle. 

If the DMX address 1 is assigned to a device, the controller "knows" that it should send all data allocated to address 1 to this device 

regardless of its position in the DMX network. 

SERIAL CONNECTION OF MULTIPLE LIGHTS

1. Connect the male XLR connector (3-pin or 5-pin) of the DMX cable to the DMX output (female XLR socket) of the first DMX device 

(e.g. DMX-Controller).

2. Connect the female 3-pin XLR connector of the DMX cable connected to the first projector to the DMX input (male 3-pin socket) 

of the next DMX device. In the same way, connect the DMX output of this device to the DMX input of the next device and repeat until