Cameo FLAT PRO SPOTIX CLFLATPROSP4 User Manual - Manufacturer´s

22

23

IT

ALIANO

POLSKI

ESP

AÑOL

FRANCAIS

FRANCAIS

FRANCAIS

FRANCAIS

FRANCAIS

DEUTSCH

ENGLISH

MANUFACTURER´S 

DECLARATIONS:

LIMITATION 

OF LIABILITY 

If your Adam Hall branded hardware product fails to work as warranted above, your sole and exclusive remedy 

shall be repair or replacement. Adam Halls’ maximum liability under this limited warranty is expressly limited to 

the lesser of the price you have paid for the product or the cost of repair or replacement of any components that 

malfunction under conditions of normal use.

Adam Hall is not liable for any damages caused by the product or the failure of the product, including any lost 

profits or savings or special, incidental, or consequential damages. Adam Hall is not liable for any claim made by 

a third party or made by you for a third party.

This limitation of liability applies whether damages are sought, or claims are made, under this Limited Warranty 

or as a tort claim (including negligence and strict product liability), a contract claim, or any other claim, and 

cannot be rescinded or changed by anyone. This limitation of liability will be effective even if you have advised 

Adam Hall or an authorized representative of Adam Hall of the possibility of any such damages, but not, however, 

in the event of claims for damages in connection with personal injuries.

This  manufacturer‘s warranty grants you specific rights; depending on jurisdiction (nation or state), you may be 

be entitled to additional claims. You are advised to consult applicable state or national laws for a full determina-

tion of your rights. 

REQUESTING 

WARRANTY SERVICE 

To request warranty service for the product, contact Adam Hall or the Adam Hall authorized reseller from which 

you purchased the product.

EC DECLARATION 

OF CONFORMITY 

The equipment marketed by Adam Hall complies (where applicable) with the essential requirements and other 

relevant specifications of Directives 1999/5/EC (R&TTE), 2004/108/EC (EMC) und 2006/95/EC (LVD). Additional 

information can be found at www.adamhall.com.