Cameo MOVOBEAM 100 User Manual - page 10
10
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
DMX
Pan Rev
= Pan Reverse
Normal
= no reversal of the Pan direction
Reverse
= Reversal of the Pan direction
Tilt Rev
= Tilt Reverse
Normal
= no reversal of the Tilt direction
Reverse
= Reversal of the Tilt direction
Feedback
= position correction
ON
= activates automatic position correction
OFF
= deactivates automatic position correction
Fan Control
= Fan Speed
Regular
= maximum brightness at normal fan function
Silent
= if necessary, reduced brightness with
silent fan
Mov Blackout
= Automatic blackout during head movement
ON
= Blackout during head movement
OFF
= no blackout during head movement
Calibrate
= Correction of the head position of Pan and Tilt
Pan
Position correction value -128 to +127
Tilt
Position correction value -128 to +127
TEST
= Function test
OFF
= stops the function test
ON
= step-by-step function test of LEDs and
motors (approx. 30 seconds)
Reset
= Reset
Pan&Tilt
= Resetting of the Pan & Tilt motors
All
= Resetting all motors and settings
Light intensity
Light intensity
Light intensity
Light intensity
DMX value
linear
exponential
logarithmic
S-curve
DMX value
DMX value
DMX value
DIMMER CURVES
DEVICE INFORMATION (System Info)
Pressing MODE will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "System Info" (coloured
background) and confirm with ENTER. You will then be taken to the sub-menu to display the device information. Use the UP and DOWN panels
again to select the desired sub-menu item and then press ENTER to retrieve the information.
DMX 35 Ch
ADDRESS 001
MODE xxx
Setting
System Info
DMX 35 Ch
Software Ver
VR.xx
Temp info
Time info
System Info
Software Ver
=
Displays the device software version
VR. xx
Temp info
=
Temperature display of the LED unit
LED Temp
xxC / xxF
Temp Unit
Celsius (= display in degrees Celsius)
Fahrenheit (= display in degrees Fahrenheit)
Time info
=
Operating time display
Power on
Displays the total operating time in hours
Last Run Hrs
Displays the operating time since the last operation
Press the MODE button repeatedly to return to the main display. The main display is automatically activated if no input is made within about
30 seconds.