Cameo NANOROLL 200 User Manual - page 7
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
7
DMX
SYSTEM SETTINGS AND SYSTEM INFORMATION
To adjust system settings and access system information, press the MODE button repeatedly until the display shows “Set”. Confirm with
ENTER. You can now use the UP and DOWN buttons to select and edit one of the following menu items.
UP/DOWN
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
-> ENTER ->
<- MODE
on = display permanently on
off = display goes out after
about 60 seconds of
inactivity
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
Reverse PAN direction
Barrel 1
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
Reverse direction of rotation
Barrel 1
-> ENTER
Firmware version
display
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
Reverse PAN direction
Barrel 2
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
Reverse direction of rotation
Barrel 2
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
With the help of this menu point, you define
which operating mode is enabled
if the DMX signal is interrupted
when in DMX-mode.
The last DMX
command
will be retained.
Blackout
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
Restore to
factory setting
Restore to
factory setting
Do not reset