Camera Corps Q-Ball Operation Manual - Q-Ball
Q-Ball
– Operation Manual
V6.3
Page 7 of 8
2/2/2013
RCP Panel - Master Set-up Menus
MASTER SETUP
Enter Password?
CAMERA TYPE
Channel 1 ID 1
Make
Model
Sony Q-Ball IR
MASTER SETUP
Channel 1 ID 1
ID Assignment
Normal ID 5
This main menu select screen can be reached at any time by
repeated
presses of the top left menu button.
Note that if a ‘menu’ or ‘function’ button is illuminated it will
perform some action. If unlit it will have no effect.
Before proceeding with the set-up menus a
password must be entered. This is because
any incorrect settings here may cause
complete loss of control of a particular
camera. These settings should only be
made by somebody who understands the
system!
The password is
entered by pressing
the channel buttons in
the correct sequence.
First select the channel to be set. Now using
the left hand two function buttons scroll
through the list of available camera makes.
Next select the required camera model.
Select a different channel to set another
camera type for that channel. Note that any
changes made here will set the channel to
it’s default values
This screen allows the interface box ID to
be assigned to the selected channel no. The
left hand buttons select between ‘Normal’ or
‘Multi-Camera’ style ID’s. ‘Normal’ ID’s
can be in the range 1-8 and ‘Multi-Camera’
ID’s in the ranges 1-8, 11-18, 21-28, - up to
111-118.
‘Normal’ and ‘Multi-Camera’ ID’s can be
mixed for different channels if required.
MASTER SETUP
Channel 1 ID 1
O/P Level TX Baud
4 2400
This screen allows setting of the data
level for the Audio Data O/P. Range
0-15. Default 4 for 1v pk to pk output
for a single 600ohm load.
The TX Baud rate can be set here.
Note that both these settings apply to
all channels, not just the selected one.
.
This screen allows setting whether timing data
is sent to the camera or not. It may be necessary
to inhibit timing data if multiple RCP’s are
being used.
The PTZF setting should be set to ‘Connected’
if the RCP is working into a Joystick PTZF
controller. This reduces the data rate to allow
PTZF data to be added. If the RCP is feeding
directly into a camera then set ‘Not in use’ to
allow maximum data rate to be used. Both of
these settings can be set individually for each
channel.
This screen is used to adjust the contrast
of the LCD display.
The ‘Warn Beep’ can be enabled or
disabled here. This is an audible
warning if you try to access something
which is not available and the LCD
display will show a message describing
the reason.
MASTER SETUP
Channel 1 ID 1
3D Setup
1x3D Chan
This screen is used to setup the 3D
modes of operation. It is possible to
select either 0, 1 or 2, 3D channels.
The channels are not finally set until
you exit this display using the left
menu button.
See the handbook for a full description
of 3D operation.
MASTER SETUP
Channel 1 ID 1
Contrast Warn Beep
8 Disabled
MASTER SETUP
Channel 1 ID 1
Timing PTZF
Disabled Connected
Sony Q-Ball IR
Channel 1 ID 1
Menu Selection
Main Eng Aux Setup