Cammino H 3.1 Instruction Manual - Instruction Manual
High Performance Products
INSTRUCTION MANUAL
Powerline Harmonizer H 3.1
THANK YOU FOR PURCHASING A CAMMINO PRODUCT. PLEASE READ CAREFULLY
THIS USER’S MANUAL BEFORE CONNECTING THE HARMONIZER TO THE POWERLINE.
CAUTION
TO AVOID FIRE OR ELECTROCUTION DO NOT EXPOSE THE APPLIANCE TO RAIN OR HUMIDITY
For indoor use only.
THE APPLIANCE IS SUBJECT TO HIGH VOLTAGE. DO NOT TRY TO OPEN AND IN THE EVENT OF A
MALFUNCTION OR FAILURE ASK A LICENSED DEALER. ANY UNAUTHORIZED SERVICING VOIDS THE
WARRANTY.
Place the harmonizer on a levelled and steady surface in a way to allow the container to swing
horizontally while the feet do not move from the chosen position.
Avoid positioning the harmonizer close to any source of heat or close to any other electrical or
electronic appliance which may cause an audible humming in the loudspeakers.
For proper operation, the harmonizer should be put in phase according to the following
procedure :
Connect the harmonizer to the power grid and with the POWER SWITCH TURNED OFF push the
PHASE button and check if the green light turns on. Should this not happen, unplug the power
cord from the wall socket, turn it 180° and re-plug it in and check again. In some places the green
light might turn on in both positions, this is because the powerline uses two phases to get the
220V instead of phase and neutral. In this case the harmonizer will work properly regardless of
the position of the plug.
The connected devices should be put in phase as well. For this reason the red dot on the power
socket, shows the fase.
Should the phase not be marked on your devices, you can ask a specialist for the related
electrical measurements.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Printed documentation for
setting up the appliance.