Camos CM-42A Instruction Manual - Installation
INSTALLATION
TILT CAMERA FOR VEHICLES
1. Determine a position and a direction of installation so that the back area of your
vehicle can be effectively seen on the monitor screen.
2. Fix the camera bracket to the vehicle using the provided adhesive tape and the
tapping screws with the spring washers.
3. Fix the camera between the camera bracket and sun visor by using machine screws.
Adjust the angle of the camera and fasten the screws firmly.
4. Run the cable from the monitor to the camera.
CM-112AHT
Camera Connector
1. CAMERA B+ (DC +1V)
. HEATING B+ (DC +1V)
. STAND BY
. VIDEO OUT
. AUDIO OUT
6. N.C
7. GND
Fix the camera bracket to the vehicle using
the provided adhesive tape and the tapping
screws with the spring washers.
Fix the camera between the bracket and sun
visor by using machine screws. Adjust the
angle of the camera and fasten the screws
firmly.
Installation example
TAPPING SCREW TH M4x10
SPRING WASHER M4
FLAT WASHER M4
SEM’S MACHINE SCREW M3x7
MACHINE SCREW PHW M3x5
A
B
C