Camos CM-800D Instruction Manual - page 6
10
11
* With VOL
▶, go to SUB MENU. After adjusting in SUB MENU, press MENU to exit.
The color temperature could be changed based on the lcd specification.
• DSUB ANALOG
PICTURE
1) BRIGHTNESS
2) CONTRAST
3) H POSITION
4) V POSITION
5) PHASE
6) PIXEL FREQ.
Adjust the brightness of DSUB ANALOG without affecting AV/ S-VIDEO’s
brightness.
Adjust the contrast of DSUB ANALOG without aff ecting AV/ S-VIDEO’s con-
trast.
Adjust the horizontal position of the image.
Adjust the vertical position of the image.
Remove the noises. When phase value is wrong, the image has vertical
lines especially in 1 dot on and off .
Adjust the sampling frequency of DSUB analog signal.
* With VOL
▶, go to SUB MENU. After adjusting in SUB MENU, press MENU to exit.
COLOR
1) 9300K
2) 7300K
3) 6500K
4) USER
Change color temperature : Red 42 Green 52 Blue 50
Change color temperature : Red 51 Green 46 Blue 46
Change color temperature : Red 40 Green 54 Blue 54
User customizable. (RED, GREEN, BLUE)
The tone of color can be changed from red-dish white to bluish white.
The individual color components are also user customizable.
PICTURE
COLOR
SETUP
9300K 7300K 6500K
USER
RED
GREEN
BLUE
- +
- +
- +
50
50
50
- +
- +
- +
- +
- +
- +
PICTURE
COLOR
SETUP
SOUND
BRIGHTNESS
CONTRAST
H POSITION
V POSITION
PHASE
PIXEL FREQ.
75
50
50
50
14
100
DISPLAY MODES
For the display modes listed below, the screen image has been optimized during manu-
facture.
MODE
VGA
SVGA
800 x 600
800 x 600
37.880
46.875
60.300
75.000
40.000
49.500
720 x 400
640 x 480
640 x 480
31.469
31.469
37.500
70.087
59.940
75.000
28.322
25.175
31.500
Resolution
Horizontal
Frequency(KHz)
Vertical
Frequency(Hz)
Pixel Clock
Frequency(MHz)
RECALL
4
AUTO PIC
5
TV/AV
6
Displays present status and volume level.
Select DYNAMIC, NORMAL, MILD, USER for PICTURE
Select DSUB ANALOG, EXTERNAL VIDEO, S-VIDEO
+ / +
+ / +
- / +
- / -
- / -
Sync Polarity
(H/V)
MUTE
7
• It is a function of Mute control. When you push MUTE button,
OSD display this image. This image can be toggle.
OUT OF RANGE
1) The screen shows this when signal is out of range.
2) The screen shows this when there is no signal.
3) The screen shows this when the signal cable is not
connected.
NO SIGNAL
CHECK CABLE
OSD MESSAGE
8