Summary of CNT-701
Page 1
Owner’s manual motorized 7” wide tft lcd color monitor cnt-701 pw.
Page 2
Any changes or modifications in any changes or modifications in construction of this unit device which construction of this unit device which is not approved by the party responsible is not approved by the party responsible for compliace could void the user’s for compliace could void the user’s auth...
Page 3
Warning the warning mark is intended to alert the user to the important operating instructions. Wrong operations will result in severe injury to the unit. Do not watch monitor while driving watching the video while driving may interrupt driving and may cause an accident. Do not operate any function ...
Page 4
Contents …………………………………………………………… ……………………………………………………………… …………………………………………………………… …………………………………………………………… …………………………………………………………… ………………………………………………………………… …………………………………………………… …………………………………………………………… ……………………………………………………… ……………………………………………… ……………………………………………… …………………………………………… ………………………………………… …………...
Page 5
Features 5 getting started accessories 7" wide high resolution tft active matrix display 3.Power cable with filter box ass’y 5.Mounting bracket & etc remote control & lithium battery cr2025 a lithium battery is pre-installed in the remote control unit (with insulation sheet). To use the remote contr...
Page 6
Getting started connection installation red red pink - illumination orange - reverse gear sens brown - reverse gear sens black yellow rs-232/tmc gps red avin-r avin-l avin-v white white yellow yellow to video input to video output to rear view camera video input to audio input (r) spk-l spk-r to aud...
Page 7
Monitor 7 pw no. Mode button open / close button tilt up / down button mute button cursor up / down cursor left / right , volume up / down button remote sensor short key function long key power button move up / down button menu button getting started 8 8 sd-card reader.
Page 8
8 power mode volume up / down , cursor left / right tilt in / out mute menu cusor up / down tilt up / down open remote control replacing battery 1 2 opening the battery cover. The remote control will work within the range of about 30 degrees and 3 meter distances. Notes do not expose the remote sens...
Page 9
1. Power on press any button on the unit or power button of the remote control to turn the power on. The monitor is automatically opened. When reverse wire is connected to the signal output (12v) of the reverse gear, the monitor is automatically opened and the mode is set to rvc 2. Power off press t...
Page 10
The move position can be adjusted in 4 steps by pressing more than 2 sec tilt up / down button or tilt in / out button of the remote controller. If the monitor is not parallel to the front of the unit, the move function is not operated. You can hear fast beep tone, when you operate the mechanism und...
Page 11
When you install a rear view camera, you must connect a rear view camera to rvc. If you put the gear lever to r (reverse) to move your car backward, the rear view camera video will be displayed on the screen through the rvc mode. The monitor shows the following warning picture when parking brake is ...
Page 12
You can select the menu to make this unit or video sources connected to this unit in the best conditions. 1. Press menu button to select desired menu. Each time you press menu button, the menu changes as follows. 2. Press cursor up / down button to select the item that you want to adjust. The backgr...
Page 13
: each time you press screen flip button, screen display will be changed flip mode and normal mode. The flip screen will be useful when this unit is installed in reversed mode as follows (flip mode: 180° rotated image) 7. Screen flip for memorizing re-adjusting value, press menu button and exit pict...
Page 14
Even if video3 mirror mode is set to 180 and input mode selected to rvc, screen will be changed to normal display mode when enter the menu pages. Press menu button repeatedly to show menu setting on the screen. Press cursor up / down button to select the desired item. Press cursor left / right butto...
Page 15: General
● replace with a fuse of the same amperage. If the fuse blow again, consult installation shop where you purchased it from. ● consult installation shop where you purchased it from. ● fuse is blown ● incorrect wiring power does not turn on. (no sound is produced) power it off and power it on again. If...
Page 16: General
General power supply power consumption operating temperature video input signal video output signal dimension (w × h × d) polarity weight net gross screen size lcd type lcd drive system number of pixels effective pixels back lighting color system dc 14v ( 11v ~ 15v ) 1.5 a -10 ℃ ~ +60℃ 1.0 vpp / 75Ω...