Flat-sat crank-up satellite antenna.
1. Contents: quantity description 1 antenna selfsat hd 10 1 lift and rotation unit (pre-assembled) 2 ceiling support plates 1 ceiling plate 1 rotation handle 1 elevation handle 1 spring 1 washer 1 graduation disc 1 antenna cable 5m one side with f-series connector 1 f-connector 1 protector gel 1 cab...
Direction of motion cable entry box 3. Installation planning decide where you wish to mount your satellite system. Location of the lift assembly must allow antenna to point towards the rear of the vehicle when resting in the travel position, and must clear all roof mounted equipment when being raise...
Direction of motion 4. Mounting using a 38mm diameter hole saw, cut a hole through the roof and ceiling for the centre shaft. Apply a layer of approx. 0,5 cm thick of adhesive such as sikaflex® on the bottom of the base plate. Follow the manufacturer’s guidelines for surface preparation, application...
5. Connecting the antenna connect the coaxial cable to the antenna and tighten. Feed the cable sidewise through the lift assembly, then insert cable through gland in rear of roof entry box and push cable into vehicle. Leave 70 cm of cable (see indication) from antenna to roof entry. Following glue o...
The graduation disc also will be used to indicate the approximate direction and position of the desired satellite. With the enclosed compass find out the direction north and turn the indicator "n" into this direction. Turn the indicator of rotation handle into the area of desired satellite, which ap...
7. To lower antenna: pull rotation handle down to disengage gear from ceiling plate and rotate the antenna until the pointer on the ceiling plate is aligned with the pointer on the rotation handle. Rotate elevation handle counter clockwise until you hear the antenna touch the roof (resistance will b...
