Camp-let tent trailer User Instructions

Manual is about: tent trailer

Summary of tent trailer

  • Page 1

    User instructions royal - a danish quality product t h e h o l i d ay g l o b e t r o t t e r.

  • Page 2: Table of Contents:

    2 table of contents: introduction .......................................................... 3 coupling .............................................................. 4 erecting ............................................................... 5 kitchen section ...........................................

  • Page 3: From Camp-Let

    3 congratulations on your new tent trailer from camp-let these instructions are to be used after you have re- ceived your detailed camp-let demonstration from your dealer. We have gathered vast experience in the use and erection of camp-let. By studying these instructions carefully and following the...

  • Page 4: Coupling of The Camp-Let

    4 hitch the trailer onto the tow ball and plug in the power. Double check the camp-let is firmly hitched to your car and check all the lights are working. Coupling of the camp-let 1 l indicator left yellow 2 54g fog light blue 3 31 earth white 4 r indicator right green 5 58r light right brown 6 54 s...

  • Page 5: Erecting The Camp-Let

    5 lower the front parking leg so the trailer is level. The rear supporting legs has to be screwed down and adjusted, so that the trailer stands horizontal in both directions. The supporting legs must be screwed down so the wheels nearly lets go of the ground. Unlock the camp-let. Swing the kitchen o...

  • Page 6: Erecting…

    6 before the lid can be lifted, the internal catch must be released. Erecting… take off the strap. Lift the lid and slowly lower down. The supporting legs must be adjusted, so that the lid is horizontal. Pivot fitting in transport position. Pivot fitting prior to lifting out the canvas..

  • Page 7

    7 open the zips at the top. Remove and store the protective caps, they have to be put on again, when the tent is being packed away. Pull the canvas free in one of the cor- ners, so the bar can swing free. Mount the middle piece. Pull the canvas in place again. Close all the zips. It is very importan...

  • Page 8

    8 check again that the pivot fitting is opened out. Hold the sliding bars on both sides and pull the tent up carefully. Check that the polework is centrally (on all 4 corners) positioned on the reinforcements. See the list of poles on page 19. Mount the roof supporting pole, at first in the gable pu...

  • Page 9

    9 push the sliding bars out until the win- dows are horizontal. Press stud the under bed storage/ ground piece into position. Zip the under bed storage/ground piece together with the canvas on both sides. Mount the wardrobe bar. Mount the sofa. The strap from the chair back is passed through the hol...

  • Page 10

    10 mounted supporting pole pegging note! All zips must be closed. Using the plastic pegs, start the pegging as per dia- gram, then peg in a straight line from corner to corner. Only peg the mud flaps down in poor weather using the steel wire pegs. After pegging mount the supporting poles in each cor...

  • Page 11: Kitchen Section…

    11 kitchen section… open the kitchen and slowly swing it out checking that the electrical cable does not catch the bolts next to the hinge. Pivot the supporting leg down, and tighten the wing nuts, so the kitchen is horizontal. Gas pressure: 30 mbar. Battery holder takes 2 x 6v batteries to run the ...

  • Page 12: Technical Specifications

    12 573 cm 215 cm 275 cm 160 cm 160 cm 400 cm technical specifications dimension net weight load capacity total 18 275 225 500 m 2 kg. Kg. Kg..

  • Page 13: Important

    13 before setting off, the camp-let must be packed with the weight evenly spread. The optimum tow hitch weight is 25-30 kg. The fibre glass trailer body has a 600 ltr. Capacity (aprox). There is extra storage space on the luggage rack. It is better to load the camp-let whilst it is up. Quilts, suitc...

  • Page 14

    If you have packed away the camp-let wet or even slightly damp, you must set up and completely dry it out (within 24 hours). If you have been travelling in wet conditions you must open up the camp-let (within 24 hours) to check that water has not seeped in. Carry out the same check after you wash th...

  • Page 15: Also Consider:

    Dismantling is in reverse order, remember to fold down the back rest and lye the cushions in the bottom of the trailer. Remove the centre awning pole and put the protective sleeves on. Take care not to trap the canvas under the lid and around the kitchen area. Front and rear clamps must be closed an...

  • Page 16: Details

    16 16 details ventilation for the sleeping compartments kitchen window guyed out for ventilation curtain clips the under bed storage can be mounted before the lid is lifted over the entire side window can be zipped/ rolled up, so the window area is one big mosquito net the veranda doors/windows can ...

  • Page 17: Winter Storage

    17 clean the tent for stains/spots and clean the mud flap. The can- vas can be removed by opening the zip pockets on the poles and slide out the canvas from the tent rail. Canvas and mattresses must be kept dry. Wash the glass fibre body with a mild soap. Hinges, fasteners, spindles, coupling and co...

  • Page 18: Tent:

    18 tent: clean the canvas and mud flaps (ask your dealer for advice). Remember if the canvas is wet or damp always thoroughly dry it within 24 hours. Canvas and stitching can be waterproofed again if neces- sary (ask your dealer for advice). Glass fibre body: wash the body with a mild soap, which do...

  • Page 19

    List of framework for royal: 1: roof supporting pole 2: wardrobe bar 3: supporting poles 4: veranda bar (side window) 5: veranda bar (front window) 6: ventilation poles (kitchen window) 7: ventilation poles 8: veranda bars (side window) 9: portal bars (canopy) 19.

  • Page 20: Available Accessories:

    Available accessories: insulation mats the camp-let factory stands for quality through a new standard in design, materi- als and construction. For more than 40 years we have devel- oped and produced trailers and trailer tents in our danish factory. The product program today includes camp-let trailer...