Campa ConvectAir Installation & Operating Instructions Manual - Meaning of The Symbol:
Page 14
RE-ALIGNING SETTINGS (thermostat/thermometer)
RE-INITIALIZING THE THERMOSTAT
Factory settings can be reinstated by simultaneously pressing
the 3 keys
and the Temperature adjustment
knob for 10 seconds while the thermostat is in standby
mode.
(This operation can only be carried out while the heater is in standby mode)
Exceptionally, under certain conditions, there may be a difference between the figure
displayed by your screen and that provided by the thermometer. Should this occur, you
can re-align both settings.
This adjustment is only possible when your appliance is set to between 17 and 22°C.
All doors and windows must be closed.
Let the room temperature stabilize (at least 6 hours) and avoid coming into and going out of
the room as much as possible.
The control thermometer must be placed in the centre of the room at a height of 1.20 metres.
Do not place it on furniture.
After 6 hours, record the difference between the temperature shown by your thermometer and
that displayed by the appliance.
Simultaneously press both
keys and the knurled setting button
for 10 seconds.
Turn the knurled setting button
to reset the temperature as indicated by your thermometer.
Correction up to +/- 2°C
E.g. 20.5° on the thermometer, 19.5° on the
thermostat screen. Use the knurled setting button
to correct the setting by increasing it by +1° (20.5-19.5).
13
Press 2 times on the key
to validate your choice.
This symbol appears when you attempt unauthorised actions.
E.g.
Pressing a key when the “childproof lock” has been activated.
The set point temperature cannot exceed 19.5°C.
The ECO temperature cannot exceed 18°C.
Meaning of the symbol:
OPERATING INSTRUCTIONS (continued)
6