Inst ruct io n manual cd100 mountable display with keypad revision: 1/17 c o p y r i g h t © 2 0 1 1 - 2 0 1 7 c a m p b e l l s c i e n t i f i c , i n c ..
Guarantee this equipment is guaranteed against defects in materials and workmanship. We will repair or replace products which prove to be defective during the guarantee period as detailed on your invoice, provided they are returned to us prepaid. The guarantee will not apply to: equipment which has ...
Please read first about this manual please note that this manual was originally produced by campbell scientific inc. Primarily for the north american market. Some spellings, weights and measures may reflect this origin. Some useful conversion factors: area: 1 in 2 (square inch) = 645 mm 2 length: 1 ...
Precautions danger — many hazards are associated with installing, using, maintaining, and working on or around tripods, towers, and any attachments to tripods and towers such as sensors, crossarms, enclosures, antennas, etc. Failure to properly and completely assemble, install, operate, use, and mai...
I table of contents pdf viewers: these page numbers refer to the printed version of this document. Use the pdf reader bookmarks tab for links to specific sections. 1. Introduction ................................................................ 1 2. Cautionary statements ...............................
1 cd100 mountable display with keypad 1. Introduction the cd100 is an easy-to-read panel-mountable datalogger data display. It includes a large-format keypad for input. The cd100 is compatible with several campbell scientific dataloggers. Refer to section 5 , specifications (p. 3) , for a complete l...
Cd100 mountable display with keypad 2 3. Quickstart 1. If the cd100 is to be mounted into an enclosure bulkhead, refer to section 6 , installation (p. 3) , for instructions. 2. Using an sc12 cable as shown in figure 3-1 , connect the 9-pin cs i/o port of a cr1000 or other compatible datalogger to th...
Cd100 mountable display with keypad 3 5. Specifications features: • operable with gloved hand • 16 key alpha numeric keypad • 8 line x 21 character display (64 x 128 pixel) compatibility: cr800 (not cr850) cr1000 cr3000 interface: cs i/o, sdc address 2 temperature operating: –45° to 85°c storage: –5...
Cd100 mountable display with keypad 4 4. Mount the cd100 as shown in figure 6-3 , profile of installed cd100. 5. Before tightening screws, adjust the gasket to align it just inside the edges of the display. Uniformly tighten the screws, but do not over-tighten. Figure 6-1. Template measurements for ...
Cd100 mountable display with keypad 5 figure 6-2. Template measurements for serial numbers 1311 and higher.
Cd100 mountable display with keypad 6 figure 6-3. Profile of installed cd100
Cd100 mountable display with keypad 7 7. Operation an overview of keyboard functions is presented in table 7-1 , keyboard display key functions, and figure 7-1 , display menu overview. Detailed descriptions are available in the datalogger manual. Table 7-1. Keyboard display key functions key special...
Cd100 mountable display with keypad 8 figure 7-1. Display menu overview 8. Maintenance active desiccant must be maintained in the datalogger enclosure to avoid water damage to the display electronics, the datalogger, and other contents. No other maintenance is required. Depending on the environment ...
Campbell scientific companies campbell scientific, inc. 815 west 1800 north logan, utah 84321 united states www.Campbellsci.Com • info@campbellsci.Com campbell scientific africa pty. Ltd. Po box 2450 somerset west 7129 south africa www.Campbellsci.Co.Za • cleroux@csafrica.Co.Za campbell scientific s...
