Campbell Hausfeld DG190600CK S Operating Instructions And Parts Manual
Operating Instructions and Parts Manual
DG190600CK and DG190625DI
Variable Speed
Hammer Drill
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain
the product described. Protect yourself and others by observing all safety information. Failure to comply with
instructions could result in personal injury and/or property damage! Retain instructions for future reference.
IN713303AV 8/07
For parts, product & service information
visit
www.chpower.com
BUILT TO LAST
© 2007 Campbell Hausfeld/Scott Fetzer
See Warranty on page 6 for important information about commercial use of this product.
Description
Hammer drills provide short, rapid
hammer thrusts at the same time the bit
turns. By adding impact to the drilling
tip, the material is actually pulverized,
increasing the efficiency of the drilling
process and keeping the tip of the bit
cooler. This hammer drill can be used in a
normal drilling mode as well. Other
features include variable-speed and
reversing controls, which provide the
ability to use the drill as a driver as well.
The depth stop offers greater control,
project versatility, and increases depth
accuracy.
Unpacking
When unpacking this product, carefully
inspect for any damage that may have
occurred during transit.
General Safety
Information
This manual contains information that is
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROBLEMS.
To help recognize this information,
observe the following symbols.
Danger
indicates
an imminently hazardous situation
which, if not avoided, will result in
death or serious injury.
Warning
indicates
a potentially hazardous situation
which, if not avoided, COULD result in
death or serious injury.
Caution
indicates
a potentially hazardous situation
which, if not avoided, MAY result in
minor or moderate injury.
Notice
indicates
important information, that if not
followed, may cause damage to
equipment.
CALIFORNIA PROPOSITION 65
You can create dust when
you cut, sand, drill or grind
materials such as wood,
paint, metal, concrete, cement, or other
masonry. This dust often contains
chemicals known to cause cancer, birth
defects, or other reproductive harm.
Wear protective gear.
Warning
This
product or its power cord contains
chemicals known to the State of
California to cause cancer and birth
defects or other reproductive harm.
Wash hands after handling.
The following safety precautions must be
followed at all times along with any
other existing safety rules.
1. Read all manuals included
with this product carefully.
Be thoroughly familiar
with the controls and the
proper use of the
equipment.
2. Only persons well acquainted with
these rules of safe operation should
be allowed to use the tool.
Safety glasses and ear
protection must be worn
during operation.
REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.
Specifications
Voltage
120 V, 60 Hz
Chuck Size
1/2" (13 mm)
Max Bit Size
1/2" (13 mm)
Blows per Minute
42,000
RPM
0 - 3000
Power Rating
6 Amps
MANUAL