Campbell Hausfeld IN198203AV Operating Instructions Manual

Summary of IN198203AV

  • Page 1

    Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Reta...

  • Page 2

    2 operating instructions 2. Use of a ground fault interrupter (gfi) is strongly recommended. Ground fault interrupters can significantly reduce the possibility of injury if an electrical short occurs. In order to install a gfi, the generator neutral wire must be internally grounded to the generator ...

  • Page 3

    3 operating instructions load devices 1. All load devices and extension cords should use three prong terminals. Refer to the following chart for extension cord and cable size requirements. 2. Allow the engine to run for 2-3 minutes before applying any electrical loads. 3. The 120 volt receptacles ar...

  • Page 4

    4 operating instructions 2. In accordance with national and local standards, a double throw transfer switch must be installed in the system. Always shut off main power prior to temporary connection of the generator to a building electrical system. Installation of the generator as a backup electrical...

  • Page 5

    5 operating instructions alternator field is not energized low output voltage with no load high output voltage with no load low output voltage under load erratic output voltage noisy operation 1. Engine speed is too slow 2. Open, shorted, or incorrect wiring 3. Faulty capacitor 4. Open or shorted fi...

  • Page 6

    6 operating instructions control panel models only yellow white 120 v duplex receptacle nema 5-15r tab broken on brass side 240 v duplex receptacle nema 6-20r gn gn gn green gn red red circuit breaker circuit breaker red red blk blk blk blk idle control circuit board idle control magnet idle control...

  • Page 7

    7 operating instructions lamp dim lamp bright testing generator diodes the following method eliminates the need to disconnect the diodes from the generator wiring. 1. Use a 12 volt battery and automotive lamp (type 5001) to test the diodes in the generator. 2. Connect the battery and lamp as shown i...

  • Page 8: Notes

    Notes operating instructions 8.