Airless paint sprayers please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/o...
2 operating instructions and assembly instructions airless paint sprayers description airless paint sprayers are capable of spraying a wide variety of latex, oil-based, and alkyd paints, as well as stains, preservatives and other non-abrasive finishes. These sprayers are also powerful and versatile ...
Airless paint sprayers 3 operating instructions and assembly instructions safety guidelines important safety instructions save these instructions this manual contains information that is very important to know and understand. This information is provided for safety and to prevent equipment problems....
4 operating instructions and assembly instructions airless paint sprayers skin injection hazard: ● high pressure spray can inject toxins into blood stream. If injection occurs, seek emergency medical treatment. Use a face mask/respirator and protective clothing when spraying. Always spray in a well ...
● do not kink or over-bend the hose. ● do not expose the hose to temperatures or to pressures in excess of those specified by the manufacturer. ● do not use the hose as a strength member to pull or lift the equipment. ● always wear appropriate gloves, eye protection, and a respirator or mask when pa...
Power switch pressure control knob outlet valve prime/ spray control suction filter suction tube bypass tube bypass tube clip 6 operating instructions and assembly instructions airless paint sprayers preparation airless painting systems, unlike most other power tools, require additional care to ensu...
Airless paint sprayers 7 operating instructions and assembly instructions www.Chpower.Com turn pressure to high (completely clockwise) 4 starting instructions while pulling trigger, direct fluid stream along inside of bucket 7 power switch location 3 tip in cleaning position 6 5 turn prime/ spray co...
8 preparation (continued) 9. After completing the flush/testing process, purge the pump of fluid. 10. Repeat the preceding steps using paint instead of cleaning solvent. Note: strain and thin paint before using. All paint may have particles that will clog filter and spray tips. Remove any skin which...
Airless paint sprayers 9 operating instructions and assembly instructions www.Chpower.Com spraying instructions (continued) intermittent use if you are spraying and decide to stop for several minutes, lock the spray gun trigger and submerge the tip in a container of water (see figure on page 8). Thi...
10 cleanup cleanup for overnight storage note: cleaning and maintenance of the pump are the most important steps you can take to ensure proper operation and a long life for your airless paint sprayer. Please follow the cleaning instructions carefully and . . . Wear all necessary safety gear necessar...
11 operating instructions and assembly instructions airless paint sprayers cleanup for changing paints or temporary storage for more than one night wear all necessary safety gear necessary tools / materials: • rag • gloves • two (2) buckets • at least one (1) gallon of clean- ing fluid (water or min...
12 airless paint sprayers operating instructions and assembly instructions cleaning hose and gun www.Chpower.Com turn prime/ spray control to spray (knob is horizontal) if reversible tip is used, rotate spray tip to clean position. While pulling trigger, direct fluid stream along inside of bucket 9 ...
13 operating instructions and assembly instructions airless paint sprayers www.Chpower.Com finishing touches/shutdown cleanup for changing paints or temporary storage for more than one night (continued) 17. Make sure prime/spray control is in spray position to reduce dribbling. 18. Turn pressure to ...
14 airless paint sprayers operating instructions and assembly instructions www.Chpower.Com storage short term (less than one week) wear all necessary safety gear necessary tools / materials: • pump protector solution • plastic wrap • 3/4 in. Or adjustable wrench oil or alkyd based paint if sprayer c...
Spray gun maintenance pump damage may occur if these instructions are not followed. Before performing any maintenance, make sure to relieve pressure from system and disconnect power from sprayer. • do not use oil based solvents to clean equipment after using latex based coatings. Use only warm soapy...
16 operating instructions and assembly instructions airless paint sprayers www.Chpower.Com maintenance chart maintenance item check replace user serviceable detail notes product safety labels before each use as required yes call for location of product safety labels and related part numbers. Trigger...
Airless paint sprayers 17 operating instructions and assembly instructions specifications operating pressure power ratings safety features 0-2800 psi 120 volts ac spray gun trigger lock 60 hz spray gun trigger guard 7,0 amps spray gun pressure diffuser prime/spray valve over pressure relief model we...
18 for replacement parts and accessories, call 1-800-626-4401 operating instructions and assembly instructions please provide following information: address parts correspondence to: - model number campbell hausfeld - serial number (if any) attn: customer service - part descriptions and number as sho...
19 operating instructions and assembly instructions replacement parts list for replacement parts and accessories, call 1-800-626-4401 please provide following information: address parts correspondence to: - model number campbell hausfeld - serial number (if any) attn: customer service - part descrip...
Troubleshooting chart www.Chpower.Com operating instructions and assembly instructions 20 symptom possible cause(s) corrective action motor hums and does not run 1. Supply voltage too low 1. Do not use an extension cord, it is better to add hose length. Use portable generator with a 2400 va minimum ...
21 operating instructions and assembly instructions www.Chpower.Com troubleshooting chart (continued) symptom possible cause(s) corrective action pump primes and builds pressure, but does not maintain pressure once trigger is pulled 21. Clogged suction filter 21. Remove suction filter and clean. Als...
22 airless paint sprayers to remove trash that has been caught in the valves, the unit can be force fed. With pump on and prime/spray knob turned to “prime” position, pour the appropriate solvent into the suction tube and then fold hose as shown opposite. While firmly squeezing the suction tube, sli...
Notes 23 operating instructions and assembly instructions.
24 www.Chpower.Com operating instructions and assembly instructions airless paint sprayers limited warranty 1. Duration: from the date of purchase by the original purchaser as follows: paint application systems - 1 year. All paint spray guns and paint application accessories - 1 year. 2. Who gives t...