Campbell Hausfeld PW2220 Product Manual

Manual is about: Campbell Hausfeld Gasoline Powered Horizontal Pressure Washer Product Manual

Summary of PW2220

  • Page 1

    Built to last gasoline powered horizontal pressure washers product manual pw2220, pw3005, pw3221, pw3228, pw3520 carefully read and understand these instructions before operating your pressure washer. © 2003 campbell hausfeld/scott fetzer in462600av 8/03 frequently asked questions . . . . . . . . . ...

  • Page 2: Frequently Asked Questions

    Pressure washers www.Chpower.Com frequently asked questions how do i start my pressure washer? 1. Make sure you have gas and oil in the engine. 2. Turn the water on, then trigger the gun to make sure the water will flow smoothly out of the nozzle or tip. 3. Put the engine throttle control in the “fa...

  • Page 3: Notice

    Ble support. Keep good footing and balance at all times. 10. Follow the maintenance instructions specified in the manual. Risk of injection or severe injury. Keep clear of nozzle. Do not discharge streams at persons. This product is to be used only by trained operators. Always remove lance from gun ...

  • Page 4: Pre-Operation

    Pressure washers www.Chpower.Com 4 pre-operation unpacking remove the equipment and all parts from the carton. The carton should contain the following. • one pressure washer (pump, engine, cart base). • one cart handle assembly. • one spray gun. • one lance with nozzle. • spray tips (not included wi...

  • Page 5: Pre-Operation (Continued)

    Trigger safety latch in the engaged position, the trigger safe- ty latch prevents the gun from being trig- gered accidentally. Push the latch fully down to engage it (see figure 9). Always engage the trigger safety latch when the unit is not in use. 5 pre-operation (continued) www.Chpower.Com figure...

  • Page 6: Notice

    Pressure washers www.Chpower.Com equipped, turn on the on/off switch to the “on” position. 7. Start the engine. If the engine is cold, completely close the engine choke. If the engine is warm, leave the choke open or just partially closed. Unlock the trigger safety latch on the gun. Grasp the starte...

  • Page 7: Operation (Continued)

    If there is not a plastic adjustment knob located on the pump (see figure 10), then the pressure cannot be adjusted. The only way to adjust the pressure is to move closer or further away from the cleaning surface and adjust the spray fan angle as shown in the next section. Adjusting the spray fan an...

  • Page 8: Notice

    Pressure washers 1. Before triggering the gun, adjust the nozzle or quick connect tip to a wide fan pattern. 2. Place the nozzle approximately 4-5 feet away from the cleaning surface. Then hold the nozzle at a 45 degree angle to the cleaning surface. Trigger the gun. 3. Vary the fan pattern spray an...

  • Page 9: Operation (Continued)

    9 operation (continued) sliding down and streaking. Wait a couple of minutes for the detergent to break down the dirt and grime. Use a brush to lightly scrub heavily soiled areas. Never allow the deter- gent to dry on the cleaning surface. 2a. To rinse or to return the nozzle to high pressure, relea...

  • Page 10: Maintenance

    Pressure washers 10 maintenance observe regular maintenance intervals to ensure maximum performance and life from the pressure washer. Refer to the schedule for recommended mainte- nance. If you operate the pressure washer in dusty conditions, perform maintenance checks more often. Engine oil changi...

  • Page 11: Maintenance (Continued)

    Engine oil type sae 10w-30 sae 30w (above 60 o f) engine oil capacity briggs and stratton vanguard series 7-8 hp 30 fl. Oz. Vanguard series 11-13 hp 51 fl. Oz. Intek series 8-10 hp 28 fl. Oz. Honda engines gx series 4-6.5 hp 20 fl. Oz. Gx series 8-13 hp 37 fl. Oz. Robin engines ex series 4.5-7 hp 20...

  • Page 12

    Pressure washers www.Chpower.Com troubleshooting chart - gasoline powered pressure washers only symptom possible cause(s) corrective action(s) engine will not start or is hard to start engine misses or lacks power low pressure and/or pump runs rough water leakage from under pump manifold water in pu...

  • Page 13: Service Record

    13 www.Chpower.Com service record date maintenance performed replacement components required notes pressure washer will not spray detergent 1. Nozzle not pushed up far enough 2. Clog, kink, or hole in detergent suction hose 3. Hose length too long 4. Lance not functioning properly 5. Not using quick...

  • Page 14

    Pressure washers 14 www.Chpower.Com limited warranty 1. Duration: from the date of purchase by the original purchaser as follows: standard duty - one year, serious duty - two years, extreme duty - three years, maxus brand serious duty - three years, maxus brand extreme duty - five years. 2. Who give...