Campbell Hausfeld WF2034 Operating Instructions & Parts Manual

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.

Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or

property damage! Retain instructions for future reference.

IN970300AV  11/00

Operating Instructions & Parts Manual   

Model WF2034

Wire Feed

Arc Welder

BUILT TO LAST

TM

The Campbell Hausfeld WF2034 is a 70

amp, single phase 115 volt input, wire

feed arc welding machine equipped with

infinite wire speed control to accurately

select the proper wire feed rate needed

for various welding conditions. Internal

components are thermostatically

protected.

This welding system is designed for use

with Flux Core Arc Welding (Gasless)

only. As delivered from the factory, this

welder can weld with .030” (.8mm) to

.035” (.9mm) diameter flux-cored wire.

A starter spool of .035” flux-cored wire

is included.

Unpacking

Some welder components may be

found in the wire feed compartment.

When unpacking, inspect carefully for

any damage that may have occurred

during transit. Report any damaged or

missing items by calling (800) 746-5641.

Circuit Requirements

This equipment 

requires a

dedicated 115 volt circuit. Refer to the

following chart for the correct circuit

breaker or fuse rating. Do not run

other appliances, lights, or tools on

this circuit while operating this

equipment. Extension cords are not

recommended. Blown fuses and tripped

circuit breakers can result from failure

to comply with this recommendation.

!

CAUTION

Components and Controls

1. Ground Clamp - connect to work

piece.

2. Wire Feed Gun

3. Power Cord - plug into 115 volt

outlet.

4. On/Off Switch

5. Heat Selector - Selects welding

power (high/low).

6. Infinite Wire Speed Control -

turn clockwise to increase wire

speed and counterclockwise to

decrease wire speed.

Heat

Circuit  Breaker  or

Selector

Slow Blow Fuse

Danger means a

hazard that will

cause death or serious injury if the

warning is ignored.

Warning means a

hazard that could

cause death or serious injury if the

warning is ignored.

Caution means a

hazard that may

cause minor or moderate injury if the

warning is ignored. It also may mean a

hazard that will only cause damage to

property.

NOTE:  Note means any additional

information pertaining to the product

or its proper usage.

!

CAUTION

!

WARNING

!

DANGER

Low 15 

amp

High 20 

amp

Q

UA

LIT

Y

A

SSURANCE

P

ROG

RA

M

Need

Assistance?

Call Us First!

1-800-746-5641

Description

General Safety

2

1

3

4

5

6

Figure 1

© 2000 Campbell Hausfeld / Scott Fetzer

For parts, product & service information

visit www.chpower.com

Farmhand 85