Campbell Hausfeld WG3000 Operating Instructions & Parts Manual

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.

Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or

property damage! Retain instructions for future reference.

IN211104AV  9/99

Operating Instructions & Parts Manual   

Models WG3000 and WG3060

Wire Feed

Arc Welder

BUILT TO LAST

TM

This line of Campbell Hausfeld wire feed

welders is designed to be used on

standard 115V household current. The

welders are equipped with infinite wire

speed control to accurately select the

proper wire feed rate needed for various

welding conditions. Internal components

are thermostatically protected.

These welders are designed for use with

Flux Core Arc Welding (Gasless) or Gas

Metal Arc Welding (Mig) process. As

delivered from the factory, this welder

can weld with .024” (.6 mm) to .035” 

(.9 mm) diameter wire. A starter spool

of .035” (.9 mm) flux-cored wire and a

.040 tip are included.

Unpacking

Some welder components may be

found in the wire feed compartment.

When unpacking, inspect carefully for

any damage that may have occurred

during transit. Report any damaged or

missing items by calling (800) 746-5641.

Circuit Requirements

This equipment 

requires a dedi-

cated 115 volt circuit. Refer to the

following chart for the correct circuit

breaker or fuse rating. Do not run

other appliances, lights, or tools on

this circuit while operating this

equipment. Extension cords are not

recommended. Blown fuses and tripped

circuit breakers can result from failure

to comply with this recommendation.

Components and Controls

1. Work Clamp - connect to work

piece.

2. Wire Feed Gun with .040 tip

3. Power Cord - plug into 115 volt

outlet.

4. On/Off Switch

5. Infinite Wire Speed Control -

turns clockwise to increase wire

speed and counterclockwise to

decrease wire speed.

6. Heat Selector - Selects welding

power. Four selections are possible

7. Polarity Hook-up - Attach torch

cable to (+) for MIG and (-) for flux

core wire.

Heat

Circuit  Breaker  or

Selector

Slow Blow Fuse

Danger means a

hazard that will

cause death or serious injury if the

warning is ignored.

Warning means a

hazard that could

cause death or serious injury if the

warning is ignored.

Caution means a

hazard that may

cause minor or moderate injury if the

warning is ignored. It also may mean a

hazard that will only cause damage to

property.

NOTE:  Note means any additional

information pertaining to the product

or its proper usage.

MODEL WG3000

Low (1-2)

15 amp

High (3-4)

20 amp

Q

UA

LIT

Y

A

SSURANCE

P

ROG

RA

M

Need

Assistance?

Call Us First!

1-800-746-5641

Description

MODEL WG3060

1

1

2

2

3

3

4

4 & 6

5

5

6

7

Figure 1

General Safety

© 1999 Campbell Hausfeld / Scott Fetzer

For parts, product & service information

visit www.campbellhausfeld.com

7