Campbell Hausfeld WS090001AV Additional Model Instructions

Additional Model Instructions

Model WS090001AV

Addendum to Owner’s Manual

IN170138AV  2/99 

BUILT TO LAST

TM

Shielded Metal

Arc Welder

© 1999 Campbell Hausfeld/Scott Fetzer

Description

Thank you for purchasing the

Campbell Hausfeld 70 amp Arc Welder,

Model #WS090001AV.  This instruction

sheet is to be used in conjunction with

the standard owner’s manual included

with the welder (IN198904AV).  Please

refer to this sheet for WS090001AV

assembly instructions.

Please read all 

warning instructions in

the owner’s manual

before operating. 

Components

The WS090001 comes with the

following additional equipment:

•

Automatic amperage adjustment -

low position for 1/16” rods and

high position for 5/64” rods--for

ease of use.

•

Cable storage clips (shown in

Handle Assembly) for safer storage

of welding cables.

Handle Assembly

1. Align the end holes on the handle

with the holes on top of the welder,

then secure with screws (Figure 1).

!

NOTICE

MANUAL

2. Insert cable clips by pressing inward

on sides of clip and pushing into

the slots on front of handle as

shown in Figure 2. Repeat for

opposite side of handle.

Electrode Holder Assembly 

(Refer to Figure 3)

1. Remove insulation handle from the

holder body by pulling the two

pieces apart.

2. Slide the other weld cable through

the handle.

3. Loosen the wire clamping screw

and slide the bare cord wire under

the clamp block. Tighten the

clamping screw and make sure the

wire is secure.

4. Slide the handle over the electrode

holder body and press to stop.

Make sure the handle is secure and

there is no exposed metal on the

holder.

Figure 3 - Electrode Holder

Figure 2

Figure 1

For parts, product & service information

visit www.campbellhausfeld.com