Summary of KI590TSL
Page 1
Use and care guide island hood.
Page 2
Fig.1 fig.2 fig.3 fig.4 fig.5.
Page 3
Fig.6 fig.7 fig.8 fig.9.
Page 4
Fig.10 fig.11 fig.12 fig.13 a b fig.14 fig.15.
Page 5
Fig.16 fig.17 fig.18 fig.19 fig.20 fig.21 fig.22 fig.23 fig.24.
Page 6
Fig.25 fig.26 general carefully read the following important information regarding installation safety and maintenance. Keep this information booklet accessible for further consultations. The appliance has been designed for use in the ducting version (air exhaust to the outside – fig.1b), filtering ...
Page 7
Voltage and power correspond to the network and the socket is suitable. If in doubt ask a qualified electrician. 2. Warning ! In certain circumstances electrical appliances may be a danger hazard. A) do not check the status of the filters while the cooker hood is operating b) do not touch bulbs or a...
Page 8
The appliance has been manufactured as a class i , therefore earth cable is necessary. The connection to the mains is carried out as follows: if not provided, connect a plug for the electrical load indicated on the description label. Where a plug is provided, the cooker hood must be installed in ord...
Page 9
The lower part . - please attention that the arrow is positioned on the same side as the appliance controls. Make 4, Ø8 holes in the ceiling and drive in 3 screws without completely tightening them(fig2). Pay attention not to insert the screw into the hole marked with an x on the hole template (the ...
Page 10
- if the cooker hood is supplied with a lower chimney piece that must be fixed to the hood body with screws, remove the anti-grease filters from the hood by acting on the relevant handles (fig.12). Then screw the lower chimney piece pipe to the inside of the hood, using screws p (fig.13). Re-locate ...
Page 11
Every four months. The saturation of the active carbon filter depends on the frequency of use of the appliance, by the type of cooking and the regularity of cleaning the antigrease filters. (fig.14) to remove the charcoal filters place on hand on one filter at a time and turn it toward the front par...
Page 12
Function keys: (fig.18) a == off b == speed 1/“ － ”control c == speed 2/“ ＋ ”control d == speed 4 e == light by pressing key b 、 c or d individually, the speed for each key will be the same as above table. At the same time indicated light will flash on the each function key button. To stop the speed...
Page 13
Function key button. To stop the speed function press key b. If speed 3 is required ， press key d and adjust“ ＋ ”. At speed 3 program both key c and key d indication light will flash on each function key button. To on the light press key e. To off the light press key e again. Function keys: (fig.21,...
Page 14
Display flashing, push key a to switch to set hours and minutes, and then push c or e to set the correct time. The clock’s system is 24 hours. When the motor is on, push the key b, the light is on, at the same time it shows “ ” is flashing as well on the digital display ， and to push key b to switch...
Page 15
If the motor, light are working together, or only motor is working, pushing a, automatic switch off timer is on, and it will delay 15 minutes to turn off the motor and light. To push b or d to adjust the time, and to push a again to stop the timer. Function keys: (fig.24, fig.26) a == infrared remot...
Page 16
Too near the cooking stove stove strong cooking smell charcoal filters not installed in re-circulating mode, charcoal filters must be installed oil dripping onto stove oil cup missing or not installed remove aluminum filter and replace oil cup aluminum grease filter saturated wash the aluminum greas...