Summary of RB2200
Page 1
Caution: please read this manual carefully before using this product instruction manual rb2200
Page 2
- 1 - 1. 在装配和使用吸尘器前请阅读本说明书。 this cleaner is for domestic use only commercial use will void warranty when using your vacuum, basic safety precautions should always be observed, including the following: read all instructions before using this vacuum. Warning: to reduce the risk of fire, electrical sho...
Page 3
- 2 - 13. Do not use without all filters in place. Use only filters and accessories provided by godfreys . Failure to do so will void the warranty. 14. Turn off all controls before plugging or unplugging vacuum cleaner into electrical outlet. 15. Use extra care when vacuuming on stairs. 16. Do not p...
Page 4
- 3 - names of parts and components 1 2 3 4 5 6 7 8 9 10
Page 5
- 4 - 1. Power plug 2. Cord rewind pedal 3. Cyclone dust container 4. Hose 5. Accessory bracket 6. Handle 7. Air escape pushbutton 8. Metal extension pipe 9. Switch pedal 10. Air outlet grill and hepa filter 11. Floor tool accessories: 1. Crevice nozzle 2. Combination brush figure (1) figure (2).
Page 6
- 5 - 1. Before assembling the cleaner, please check the packing, the vacuum cleaner and accessories for any signs of damage .Do not use damaged appliance it could be dangerous. Confirm all parts and components for the cleaner are received by referring to parts and components list. 2. Please remembe...
Page 7
- 6 7 - figure (4) 2. Assembly and removal of dust container as is shown in figure (4), place the bottom of the dust container on the base of the machine body, and press down the dust container to lock in to place. To remove the dust container, press down the handle of the dust container and pull aw...
Page 8
- 7 - assembly of metal extension pipe and floor tool insert the handle into the metal extension pipe, then insert the other end of the metal extension pipe into the floor brush, and adjust to the pipe to desired height. How to start 1. Pull out the mains cable to the yellow mark insert the power pl...
Page 9
- 8 - suction control to reduce the suction slide the suction control up as is shown in figure (7). Protective devices for motor 1. A temperature limiter switches the vacuum cleaner off automatically if it gets too hot. This can occur if for instance hose, pipe or filters are blocked. Switch the vac...
Page 10
- 9 - 1. Switch off cleaner and disconnect power before any maintenance 2. Empty dust container after every use 3. Clean front filter every 3 months by washing it in mild dishwashing solution and rinse well. Dry for 24 to 36 hours before refitting to the cleaner refer to (fig 10) replace filter ever...
Page 11
- 0 1 - empty dust container after every use 1. To remove the dust container refer to fig 4 2. To empty the dust container place the container over the rubbish bin press down the releasing button at the bottom of the dust container as is shown in figure (9). And tap the container gently to release t...
Page 12
- 11 - figure (10) replacement of hepa filter hepa is installed behind the air outlet grill. It is not washable when the surface is clogged by dust the filter should be replaced by a new one to maintain good suction (figure 11) and to prevent over heating and cutting out figure (11) replace this fil...
Page 13
- 1 2 - fault treatment the cleaner cannot operate. 1. Check whether the power plug is inserted securely; pull out the plug and then reinsert it in the power socket; 2. Check whether the power socket is turned on 3. Check whether the switch on the cleaner is in “on” position. Poor suction. Getting t...