Campomatic WBC12DZ Instruction Manual - Electrical Connection
4
Electrical Connection
This unit should be properly grounded for your safety. The power cord of this unit is equipped with a 2-‐pin plug which
matches with 2-‐pin wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or
remove the ground wire from the power cord supplied.
Use of extension cords is not recommended.
This unit requires a standard 220V-‐50HZ electrical outlet with 2-‐pin plug.
The cord should be secured behind the wine refrigerator and not let exposed or dangling to prevent accidental injury.
Operation
It is recommended that you install the wine cooler in a place where the ambient temperature is between 10-‐26
°
C (50
°
F -‐80
°
F). If the ambient temperature is above or below recommended temperatures, the performance of the unit
may be affected.
The temperature may fluctuate depending on whether or not the interior light is on or off or whether the bottles are
located on the upper, middle or lower section.
How to use the press-‐buttons on the Display Panel:
You can set the temperature as your desire by pressing the button. There are three press-‐button on the panel “ ” and
“ ” to adjust the temperature by 1
°
C among 7-‐18
°
C.
You can turn the interior light on or off by pressing the “Light” button.
Care and Maintenance
Cleaning your wine cooler
l
Unplug the wine cooler and remove the bottles.
l
Wash the inside with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking
soda to a quart of water.
l
The outside of wine refrigerator should be cleaned with mild detergent and warm water.
l
Draw out the water box at the bottom, and wash.
Moving your wine cooler
l
Remove all the bottles.
l
Securely tape down all loose items inside your wine refrigerator.
l
Turn the leveling legs up to the base to avoid damage.
l
Tape the door.
l
Be sure the wine refrigerator stays in the upright position during transportation.
Warning
Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by an authorized Products service center.