CamTron CMNC-200 Operating Instructions Manual - page 24
Cywatch HD Megapixel IP camera Operating Instructions (Ver. 1.0)
CamTron Industrial Inc.
23
The Cywatch HD Megapixel IP camera has one sensor port and one relay port. Actual numbers of
sensor, replay ports may vary depending on models.
When a decoder system instead of a PC client is connected to a Cywatch HD Megapixel IP camera,
one system becomes a Local system and the other a Remote system (Generally a system which is
being used by the user is called as Local system). Then, actions for events can be configured for
events from remote system as well as for local system. For example, it is possible to turn on an
alarm device in local(center) decoder system when a sensor device in remote(site) IP camera is
triggered. Local section configures the actions for events from local(self) system, and configuration
activates local devices and Remote sections configures the actions for events from remote(peer)
system.
For each event, E-mail notification and/or FTP upload can be checked. If the event occurs, the server
sends an E-mail and/or uploads a video clip to the specified FTP server.
The following table lists the possible actions for events.
Action
Description
Alarm
Triggers alarm(relay) port.
Sends E-mail to the specified address. AVI file can be attached
FTP
Upload AVI file to a specified FTP server
Preset
On corresponding event, PTZ moves to the associated preset position.
Once it moves to the position, it doesn’t come back to original position
automatically.
Sensor
Configure the actions when the sensor is activated. Multiple actions can be set for a single
event.
On Video Loss
Configure the actions when video input signal is lost. Multiple actions can be set for a single
event.
On Motion
Configure the actions when motion is detected. Multiple actions can be set for a single event.
On Disconnect
Configure the actions when the link(connection) with peer system is disconnected. Multiple
actions can be set for a single event.
Alarm activation duration
Set the duration of alarm activation in case of an event. If it is set to continuous, it will be in
active state until an operator reset it manually.