Canadian Comfort Industries Corn Stove Operations & Installation Manual - Operating Your
OPERATING YOUR
CORN BURNING STOVE
11
Cleaning Procedure:
When the grate starts to fill up you will need to complete the following:
a. Shut the stove off and remove pellet chute guard
b. Remove the grate and dump ash & clinker out of the grate into a metal container
c. If residue adheres to the grate, use an edged tool to scrape it away
Cleaning intervals will vary in time from a low of 8 hours to as much as 30 hours or more
depending on such factors as fuel feed rate, hybrid being used, cleanliness and dryness of fuel.
Reinsert your grate and restart as per items 1-5 on the previous page.
FINE TUNING YOUR STOVE
FUEL
FEED RATE
SETTING #1
(LOW)
FUEL
FEED RATE
SETTING #4
(HIGH)
FUEL
FEED RATE
SETTING #1
(LOW)
FUEL
FEED RATE
SETTING #4
(HIGH)
INCREASES
feed rate
DECREASES
feed rate
Do NOT use a metal object to adjust your trim
pots. Try using a plastic non-metallc object
(eg. insulated shaft screwdriver, pen cap, etc.)
Fuel feed rate at the lowest (#1) and highest (#4) settings can be changed by adjusting the #1 or #4 trim
pots located on the control panel. To INCREASE fuel feed rate, turn the trimmer COUNTER CLOCKWISE.
To DECREASE fuel feed rate, turn the trimmer CLOCKWISE.
Once the damper rod is set and your corn is burning steadily (ie. no popcorning),
you are ready to fine tune your stove. Fine tuning is required due to the differences
in installation configuration, geography, insulation of the home, and quality of corn.
First, switch to feed rate #1 by pressing the START / FEED RATE button
until the #1 LED lights up.
Turn the #1 trim pot COUNTER CLOCKWISE until the dial
stops, then turn back to 8-2 o’clock position as illustrated.
By adjusting the trim pots as described above, you are
ensuring that your stove is now at its optimal settings.
Turn the #4 trim pot CLOCKWISE until the dial stops, then
turn back to 10-4 o’clock position as illustrated.
Turn the #1 trim pot COUNTER CLOCKWISE until the dial
stops, then turn back to 9-3 o’clock position as illustrated.
Turn the #4 trim pot CLOCKWISE until the dial stops, then
turn back to 9-3 o’clock position as illustrated.
TRIM POTS
WITH FACTORY
DEFAULT SETTINGS
COUNTER-
CLOCKWISE
CLOCKWISE
Fuel Rates
At this point, your stove should still be running on
the #1 setting (low). Let this burn for approximately
10 minutes before making any further adjustments.
ALSO: The #1 and #4 trim pot dials ONLY adjust fuel feed rates 1 and 4.
CORN
PELLET