Canal CJ3000-2 User Manual - page 4
Figure 1. Centrifugal Juicer labeled assembly drawing.
Assembly Instructions
WARNING : Do not switch on the machine until it is
properly assembled. Unplug power cable from wall
during assembly.
1) Ensure the machine is positioned on a clean, flat surface.
2) The Juice Bowl should be sitting correctly in one of eight
positions.
3) Fit the basket onto the drive block with both drive pins and
motor shaft protruding through the holes in the bottom of the
basket.
4) Carefully fit the bottom blade so that the drive block pins
protruding through the bottom of the basket fit into the holes
on the back of the blade. Make sure the bottom of the basket
is clean before fitting blade.
5) Make sure the blade-securing nut is securely fastened. Use
a 22mm spanner to tighten this nut.
6) The top cover may be fitted in two positions. Ensure that the
two pins from the bottom latch assembly slot into the holes in
the top cover before clamping the latches down. The latches
should be firm but not over tight. The latches can be
tightened by turning the hooks clockwise and loosened by
turning them anti-clockwise.
7) Insert the pulp extraction duct into position at the side of the
lid. Fasten using the pulp duct fixing screw.