Canarm DUAL MOUNT SERIES Installation Instructions Manual - page 6
Pg. #6
Pg. #7
NOTE: Once ground wires are connected, carefully tuck all wires and marrettes
into the metal outlet box making sure that the wires are clear of the
hemisphere and downrod when positioned in mounting bracket.
- Push all connected wires up into ceiling box.
- Position the receiver into the canopy as shown direction.
C
Reciever
Mounting
Plate
Canopy
Hook
Fig.6
-
After making the wire connections, ensure the wires should be spread
apart with the grounded conductor and the equipment-grounding
conductor on one side of the outlet box and the ungrounded conductor
on the other side of the outlet box.
-
Ensure the splices after being made should be turned upward and
pushed carefully up into the outlet box.
120 V
SUPPLY CIRCUIT
Fan
Fig.5
In Quebec, the installation of this product must
be carried out by a qualified electrician.
3
3
.
.
ELECTRICAL HOOK-UP
B
MOUNTING FAN ASSEMBLY
- Place two screws and washers on mounting plate (marked B on diagram)
which correspond with slots in canopy. Screw in two turns.
- Position canopy to mounting plate aligning slots to screws (marked B on
diagram) then turn to lock.
- Position and tighten the two screws and washers (marked A on diagram)
then tighten the two screws (marked B on diagram).
ENGAGE HEMISPHERE (Downrod Mount Only)
- Carefully rotate fan assembly until groove in hemisphere locks over tab of
canopy assembly.
4.
5.
WARNING: Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket
faces towards the top of the slope. Depending on the slope, a longer
downrod may be required to prevent fan blades from hitting the ceiling.
Downrod
Hemisphere
Groove
(A)
(B)
(B)
Washers
(A)
Fig.7a
Fig.7b
MOUNT BLADE BRACKETS TO BLADES
Cast Blade Brackets
- Place blade bracket screw through flat
washer, fibre washer and blade.
- Align with corresponding hole in
blade bracket.
- Repeat with (2) remaining screws
and tighten.
Stamped Blade Brackets
- Place blade bracket screw through
hole in blade bracket.
- Align with corresponding hole in blade
bracket.
- Place fibre washer and flat washer
over blade bracket screw and secure
with hex nut.
- Repeat with (2) remaining screws and
tighten
6.
- Take out hardware package.
- Take out hardware package.
Hex Nut
Blade
Bracket
Blade Bracket
Screw
Fibre Washer
Flat Washer
Lock Washer
Fig. 8b
Blade Bracket Screw
Fibre Washer
Flat Washer
Blade Bracket
Fig. 8a
Blade Bracket Screw