Canarm HUGGER STYLE Series Installation Instructions Manual

Summary of HUGGER STYLE Series

  • Page 1

    I i n n s s t t a a l l l l a a t t i i o o n n i i n n s s t t r r u u c c t t i i o o n n s s questions or concerns contact canarm at: 1-800-265-1833 (english) 1-800-567-2513 (french) monday through friday 8:00 a.M. To 5:00 p.M. E.S.T. Ligh ting & fans ec lair ages & ventilat eu rs note: for optim...

  • Page 2

    Pg. #2 pg. #11 instructions a ceiling fan has a completely internal switching system for total operation by way of pull chains. On a fan/light combination, pull chains will exist: one for light, on and off. The second is for fan speeds. This will be marked (speed) on the fan switch housing. 1st pull...

  • Page 3

    1. Wooden joist 2. Ceiling 3. Approved (csa for canada and ul for u.S.) ceiling fan box (not provided) 4. J-hook 5. Blade bracket (cast metal) 6. Mounting bracket 7. Outlet box screws (not provided) 8. Motor 9. Lock washer 10. Mounting bracket screws 11. Mounting bracket side screws 12. Lock washer ...

  • Page 4

    Pg. #4 pg. #9 1. 2. 6. 7. A inst inst alla alla tion tion install mounting bracket - install j-hook through centre of outlet box and into the wooden joist. - mount “mounting bracket” to outlet box using outlet box screws. Electrical hook up - there are several different wiring combinations that can ...

  • Page 5

    Pg. #8 electrical hook up (continued) - hang fan on mounting bracket by holding motor so that inside of motor is pointing down, insert “t” slot style end of motor bracket into rectangular cut out in mounting bracket. Note: remove screw and lock washer from “t” slot end of motor bracket before hangin...

  • Page 6

    Screws and lock washers style #2 mount motor to mounting bracket - place the looped end of the safety cable over the j-hook. - remove the four bottom screws and washers from the mounting bracket. - remove the temporary hanging hook. - align motor with mounting bracket and slide in place until the fo...