Summary of CD 623
Page 1
User instructions en cd 623 cd 623 x.
Page 2: Fig. A
3 contents safety advice setting up, installation opening the door water softener unit adjusting the upper basket loading the dishes information for test laboratories loading the detergent and rinse aid cleaning the filters some practical hints routine cleaning and maintenance description of the con...
Page 3
5 installation (technical notes) after unpacking, adjust the height of the dishwasher. For the dishwasher to work correctly it must be level. Adjust the feet so that the machine does not tilt by more than 2 degrees. If it you need to move the machine after removing the packaging, do not try to lift ...
Page 4
7 the filter d must be inserted between the tap b and the inlet hose a, remembering to fit the washer c. If the dishwasher is connected to new pipes or to pipes which have not been in use for a long time run water through for a few minutes before connecting the inlet hose. In this way no deposits of...
Page 5
9 regulating the water softener the table below lists different degrees of water hardness with the corresponding setting for the softener unit. Closing the door place the baskets in the machine. Make sure that both the spray arms are free to rotate and are not obstructed by cutlery, crockery or pans...
Page 6
11 adjustment of the upper basket if 27 cm to 31 cm plates are normally used, load them onto the lower basket after the upper basket has been placed in its upper position and proceed as detailed below: 1) turn the front stops a outwards. 2) take out the basket and remount it in the upper position. 3...
Page 7
13 a standard daily load is represented in figs. 1, 2 and 3. Upper basket (fig. 1) a = soup plates b = dinner plates c = dessert plates d = saucers e = cups f = glasses upper basket (fig. 2) a = soup plates b = dinner plates c = dessert plates d = saucers e = cups f = glasses with stems g = glasses ...
Page 8
15 12 international place load (ref. En 50242). Correct loading for the upper basket is indicated in fig. 4 and for the lower basket in fig. 5. A f c c c g b e d h h l i 4 lower basket (fig. 5) m = 8 + 4 soup plates n = 11 + 1 dinner plates o = 12 dessert plates p = serving dish q = cutlery cutlery ...
Page 9
3 4 3 filling the rinse aid container the rinse aid container can be found to the right of the detergent container: it has a capacity of about 130 ml (fig a "3"). Turn the cap (3) anticlockwise and pour enough liquid to last several washes, up to the maximum level shown. Replace the cap. The rinse a...
Page 10
19 practical hints selecting the programme this dishwasher offers you a wide range of wash programmes so that you can choose the most suitable according to the type of dishes and how dirty they are. Refer to the programme list to choose the most suitable programme. Useful hints in order to avoid any...
Page 11
21 the water heater element is made of a special stainless steel which after a while may change colour; this does not in any way affect its performance or its working life (only for the models with water heater element inside the tub). Both the door lining and the tank lining are in stainless steel;...
Page 12
Attention this dishwasher is equipped with an anti-overflow safety device which works even when power is switched off, and if the water level is too high the supply will automatically be closed off. Important to ensure the correct operation of the anti-overflow safety device, it is recommended not t...
Page 13
24 programme selection programme description short cold pre-wash for items that are stored in the dishwasher until you are ready to wash a full load. Once a day - for heavily soiled pans and any other items that have been left all day for washing. Energy saving programme suitable for normal soiled i...
Page 14
27 n.B.: should any of the situations occur and should the machine give a bad wash performance, it is necessary to remove the deposits from the dishes by hand since the final drying cycle hardens the deposits which a second wash in the machine would not be able to remove. If the malfunction continue...
Page 16
The manufacturer declines all responsibility in the event of any printing mistakes in this booklet. The manufacturer also reserves the right to make appropriate modifications to its products without changing the essential characteristics..
Page 17
03.03 - 41007923 - printed in italy - imprimé en italie en.