Summary of DFI 50
Page 1
Dfi 50 user instructions en.
Page 2: Fig. A
2 3 contents safety advice setting up, installation opening the door water softener unit adjusting the upper rack loading the dishes information for test laboratories loading the detergent and rinse aid cleaning the filters some practical hints routine cleaning and maintenance description of the con...
Page 3
5 installation (technical notes) important: when the appliance is located on a carpet floor, attention must be paid to ensure that there is no obstruction to the bottom vents. Make sure that the plug on the appliance remains accessible after installation. 4 safety instructions please read the instru...
Page 4
6 7 connecting the outlet hose the outlet hose should disharge into a standpipe, making sure that there are no kinks (fig. 4). The standpipe must be at least 40 cm above floor level and it must have an internal diameter of at least 4 cm. It is advisable to fit an anti-odour air trap (fig. 4 x). If n...
Page 5
8 regulating the water softener the table below lists different degrees of water hardness with the corresponding setting for the softener unit. Water softener unit depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leavin...
Page 6
11 loading dishes to load dishes for good wash performance remove any debris from the dishes (bones, tooth picks, the remains of meat and vegetables) to avoid blocking the filters, water outlet and washing arm nozzles and, as a result, reducing washing efficiency. Try not to rinse the dishes before ...
Page 7
13 12 a standard daily load is represented in figs. 1, 2 and 3. Upper basket (fig. 1) a = soup plates b = dinner plates c = dessert plates d = saucers e = cups f = glasses upper basket (fig. 2) a = soup plates b = dinner plates c = dessert plates d = saucers e = cups f = glasses with stems g = glass...
Page 8
15 information for the test laboratories. General programme comparison (see programmes selection) loading the detergent and the rinse aid. Filling the detergent container it is essential to use a detergent that is specifically designed for dishwashers either in powder, liquid or tablet form. Ref. En...
Page 9
17 the filter system (fig.A “4”) consists of: a central container that traps the larger particles. A flat gauze that continuously filters the wash water a micro filter, located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse. To achieve excellent results every time, the ...
Page 10
19 cleaning and maintenance the outside of the cabinet can be cleaned with a non-abrasive cleaning agent suitable for a gloss finish. The dishwasher does not require special maintenance, because the tank is self- cleaning. Regularly wipe the door gasket with a damp cloth to remove any food remains o...
Page 11
20 the water heater element is made of a special stainless steel which after a while may change colour; this does not in any way affect its performance or its working life. Both the door lining and the tank lining are in stainless steel; however, should spots caused by oxidation occur, this is proba...
Page 12
23 22 150 yes 110 yes 135 75 55 6 • • • • • •• •• •• •• •• •• • • • • • • • • • • • • • 65°c 65°c •• 50°c •• 50°c 65°c •• • • programme description pre-wash universal intensive 65°c eco universal 50°c daily intensive 65°c daily 50°c delicate 50°c plate- warming 65°c •• • 105 • • • • •• 50°c short co...
Page 13
25 identifying minor faults warning! Before removing any panel: 1. Turn the knob to stop. 2. Pull the electric plug out. Should the dishwasher fail to operate, before contacting the service centre, make the following checks: fault cause remedy 1 - machine completely dead 2 - machine does not draw wa...
Page 14
26 n.B.: should any of the situations occur and should the machine give a bad washing performance, it is necessary to remove the deposits from the dishes by hand since the final drying cycle hardens the deposits which a second wash in the machine would not be able to remove. If the malfunction conti...
Page 16
The manufacturer declines all responsibility in the event of any printing mistakes in this booklet. The manufacturer also reserves the right to make appropriate modifications to its products without changing the essential characteristics..
Page 17
03.02 - 41007918 - printed in italy - imprimé en italie en.