1. DL manuals
  2. Candy
  3. Hob
  4. PVI 7500
  5. Instructions For Use Manual

Candy PVI 7500 Instructions For Use Manual

Manual is about: 44001671

Summary of PVI 7500

  • Page 1

    - 1 fr notice d'emploi et d'installation table à induction gb instrucions for using and installing induction hob es instrucciones para el uso y la instalaciÓn placa de inducción nl gebruiks- en installatiehandleiding inductiekookplaat de bedienungs und installationsanleitung ceranfelder ~~~ pvi 7500...

  • Page 2: Contents

    20 - contents safety instructions - recommendations ............................................... 21 installation important notice ...................................................................................... 22 electrical connection ..........................................................

  • Page 3

    - 21 • it is strongly recommended to keep children away from the cooking zones while they are in operation or when they are switched off, so long as the residual heat indicator (h) is on, in order to prevent the risks of serious burns. • when cooking with fats or oils, take care always to watch the ...

  • Page 4

    22 - installation – electrical connection installation – important notice «the installation receiving the appliance referred to must comply with the standard in force in the installation country». The candy company does not accept any responsibility if this provision is not complied with. Caution: •...

  • Page 5

    - 23 when connecting you should: . Turn over the hob, glass side against the work top, taking care to protect the glass! . Open the cover in the following sequence: . Find the two tabs located on the sides, . Put the blade of a flat screwdriver in front of each tab, push in and press, . Remove the c...

  • Page 6: Installation - Fitting

    24 - the unit or support for the hob, as well as the walls of any adjacent units, must be made of high temperature resisting material. In addition, the laminate covering the unit or sup- port should be laid using heat-resistant adhesive to prevent it coming away. Installation: • a seal is supplied w...

  • Page 7: Installation - Fitting

    - 25 built-in: 4 fixing clamps fitting dimensions installation - fitting fitting the hob in a support unit fitting the hob above a ventilated oven* (*equipped with a cooling fan for the electrical components) it is forbidden to fit the hob above a non-ventilated oven. Opening opening opening opening.

  • Page 8: Induction

    26 - induction use procedure an electronic generator powers a coil located inside the appliance. This coil creates a magnetic field, so that when the pan is placed on the hob, it is permeated by the induction currents. These currents make the pan into a real heat transmitter, while the glass ceramic...

  • Page 9: Choosing Utensils

    - 27 e n o z n o i t c u d n i n e h c t i k n o k r a m s l i s n e t u k r a m e h t k c e h c , l e b a l e h t n o s i n a p e h t f i s w o h s h c i h w . N o i t c u d n i h t i w e l b i t a p m o c n o r i - t s a c , t e e h s n o r i d e ll e m a n e ( s n a p c i t e n g a m e s u f o m ...

  • Page 10: Presentation of The Hob

    28 - presentation of the hob 1. Hob on/off button 2. Cooking zone selection button 3. Display : heat level, booster operation or residual heat indicator 4. "-" button 5. "+" button 6. Timer selection button 7. Timer display 8 . Control locking button with indicator lamp 9. Cooking zone programming i...

  • Page 11: The Different Positions

    - 29 the different positions the different positions correspond to the following power ratings : for increased safety, the cooking zones cut off automatically if they are left on too long. The cut off depends on the heat level used. Note: the induction hob works with a generator wich supplies simult...

  • Page 12: Using The Ceramic Hob

    30 - using the ceramic hob • after powering up the hob, wait 8 seconds to activate the electronic controls. . Press the button , for 3 seconds. Electronic control of the hob is activated. In each display zone the heat level is displayed and the control led blinks. . After 10 seconds without use, the...

  • Page 13

    - 31 • pan detector when the hob is operating, the pan detector provides the advantage of automatically stopping or starting the heat of the cooking zone in contact with or on removal of the pan. If therefore offers energy savings. If the cooking zone is used with a suitable pan* : the display shows...

  • Page 14

    32 - • programming a cooking zone every cooking zone can be programmed for a maximum of 99 minutes. Only one zone, at a time, can be programmed. . Start the required zone by following the previous instructions. The control led near the heat level must be displayed, it shows that the zone is live. . ...

  • Page 15

    - 33 the programmed time can be modified at any moment by pressing the timer selection button, the timer control led must be on. When the time has run, the cooking zone goes off automatically and an audible beep sounds for 1 minute. Press the timer button to stop it. The programmed time can be reset...

  • Page 16: Cleaning The Ceramic Hob

    34 - • it is important to wait for the ceramic hob surface to cool completely before cleaning it. • only use special products for cleaning ceramic surfaces, cream and scraper. You can find them easily in the shops. • avoid spills; messes that fall onto the cooking surface burn fast and are then hard...

  • Page 17: Data Sheet

    - 35 all data is given for information only. In order to improve the quality of its products, candy may modify its appliances with technological developments which adhere to the conditions set out in the consumer code. Ceramic hob complies with the requirements of directives 73/23/ eec and 89/336/ee...

  • Page 18: Problems and Solutions

    36 - the induction hob gives shorings out. The induction hob gives a light whistling out. The cooking zones do not simmer or only fry gently. The cooking is too slow. Small scratches or abrasions on the hob’s glass surface. Metal marks. Dark stains. Light surfaces on the hob. • normal. The cooking f...

  • Page 19: Problems and Solutions

    - 37 caramelisation or melted plas- tic on the hob. The hob is not operating. The hob does not cut off. The hob stops automatically. Frequency of on/off operations for cooking zones. The hob does not operate or certain zones don’t work. “h” display, residual heat indicator, blinking. • refer to the ...