Summary of Muses 2
Page 1
Ring collar music wireless headset muses2 instruction.
Page 2
Following items are included start here usb cable ear caps.
Page 3
Volume - / trackforward volume + / trackback multifunction button status indicator turn on / off charge port product overview.
Page 4
Press the volume button "+" or "-" to turn volume up or down, you hear "beep" voice prompts once reach the maximum or minimum. Basic operation volume adjust led indicator and voice prompts instruction power on power off pairing led status stays blue for 2 seconds stays red for 2 seconds flashes red ...
Page 5
● select "muses2" . If you phone asks, enter 0000 (four zeros) for the passcode or accept the connection. The led indicator stops flashing red and blue once successfully paired. Voice prompts "connection successful". ● turn on bluetooth headset, press and hold the multifunction button for about 5 se...
Page 6
Pair another phone multipoint technology enables you to pair another phone and take a call from either. To pair with another mobile phone, follow the steps for “pair one phone”. After pairing successfully, restart the headset to connect to 2 paired mobile phone automatically..
Page 7
Nfc pairing turn on bluetooth headset, after 5 seconds, hold an nfc device against the nfc zone of the headset. The led indicator flashes red and blue, you hear voice prompts "pairing", the led indicator stops flashing red and blue once successfully paired, you hear voice prompts "connection success...
Page 8
Call answer a call end a call reject a call redial the last call mic mute on/off press the multifunction button once. Press the multifunction button once. Press and hold the multifunction button for about 2 seconds. Double-press the multifunction button in standby mode. The mobile phone will redial ...
Page 9
Switch between the headset and phone press the volume button "+" for about 2 seconds during a call, the call will be switched to the mobile phone, redo this operation again, the call will be switched back to the headset. End current call and answer new call when a new call rings during a call, press...
Page 10
Music (need media player support) music play / pause press multifunction button to play / pause music. Trackback press the volume button "+" for 2 seconds to skip track back. Switch music and call when a call rings during a music playing, the music automatically pauses to allow you to answer or igno...
Page 11
Battery indicator more features when the headset is connected to a device with ios system, a battery indicator will appear at the upper right of the system, indicating battery status of the headset..
Page 12
Charging your new headset has enough power to pair and make a few calls. When battery is low, you will hear the voice prompt " battery low ". It takes 2.5 hours to fully charge the headset. While charging, the battery indicator light is red, the indicator light stays blue once charging is complete..
Page 13
Power off switch the power button to off position to turn off the headset. (note: power off the headset to save power when not in use.) clear paired list turn on the headset, connect it to a usb charger of usb, press and hold the volume button "+" and "-" simultaneously for about 5 seconds, led flas...
Page 14
Hardware reset turn on bluetooth headset, press and hold the multifunction button, connect the headset to a usb charger, hardware reset is done. (note: the headset automatically power off, please switch the power button to off then on to power on the headset).