Cannon 10450G Use And Installation Instructions - Hotplate
The hotplate has one dual control wok burner, one large high speed burner, three
normal simmering burners and one small simmering burner. The dual control wok
burner consists of a smaller inner and a larger outer burner that can operate either
together or separately. Use of the two burners together with large pans on maximum
setting gives a very high input and reduces cooking times with respect to
conventional burners. Use of the two burners together provides a more uniform
distribution of heat on the bottom of the pan. Cookware of all sizes can be used above
the dual control wok burner. For small pans it is recommended that only the inner
burner is used.
on the fascia panel operates the outer burner.
on the fascia panel operates the inner burner.
The knob situated below the symbol
The knob situated below the symbol
The two normal simmering burners on the right hand side of the hotplate are oval in
form and can be turned through 90˚. This makes the hotplate more flexible in how it
can be used.
For cooking fish or heating oval cookware use the two burners with their longest sides
at 90˚ to the front of the hotplate.
When using the griddle or for heating rectangular, square or large cookware use the
two burners with their longest sides parallel to the front of the hotplate.
For medium size cookware use any of the two burners in any orientation.
All pans should be placed centrally over the burners.
HOTPLATE
12
❍
❍
❍
❍
❍
❍
❍
❍
❍
❍
●
❍
TO USE THE HOTPLATE
1. Press the ignition button and then push in and turn the control knob of the
chosen burner anti-clockwise to the large flame symbol. Continue to press
the ignition button until the spark lights the gas. When operating the dual
control burner there is a separate control knob for the inner and outer
burners.
2. Turn the control knob anti-clockwise to the desired setting.
Only turn the control knob between the large flame symbol and the small
flame symbol for adjusting the setting.
3. To turn off, turn the control knob fully clockwise to the O position.
DO NOT use mis-shapen pans which may be unstable.
DO NOT use round base woks directly on the pan supports.
Each burner is fitted with a spark ignition electrode for lighting the gas.
To ensure rapid lighting of the burners every time they are used, the electrodes must be
kept clean and dry. Remove any food spillage or cleaning materials from the electrodes
using a small nylon brush such as a tooth brush.
Access to the ignitor can be achieved by lifting off the loose burner parts carefully when
the burners are cool.
If aluminium based pans are used, a silvery deposit may appear on the top edge of the
pan support fingers. See ‘Care and Cleaning’ section for further information.