Cannon CT-1000 Manual - Turning On The Ct-1000

13

CANNON

®

 CT-1000 Constant Temperature Bath

Revision 3.1a—February, 1998; 

CANNON

®

 Instrument Company

P.O . Box 16 • State College, PA • USA

3

BATH OPERATION

NOTE

The various functions controlling the bath are printed at the bottom of the

front panel of the CT-1000. These functions, reading from left to right, are:

1) Power, 2) Temperature, 3) Temperature Adjust, 4) Preheat, and 5)

Limit Control. In this manual the five functions are printed in boldface

upper- and lowercase letters (to match their typeface on the panel). The

switches and dials controlling each function are also printed in boldface

type, but in capital letters (to match their typeface on the panel).

Turning on the CT-1000

1. Turn the Power BATH switch on (Figure 14, A).

NOTE

The bath heaters will not be activated if there is no liquid in the bath.

Figure 14: Bath control panel

2. Set the Limit Control  TEMPERATURE ADJUST dial (Figure

14, B) to 999 (turn the dial clockwise to its furthest setting) to enable

the bath to heat properly. Proper technique for resetting the dial after

the bath reaches operating temperature is described in the instruc-

tional video and in the following section of the manual

3. Turn on the Power LIGHT switch (Figure 14, C) to illuminate the

interior of the bath.

4. Move the Temperature Adjust SELECT switch (Figure 14, D) to

the left.

5. After releasing its lock, move the Temperature Adjust FIXED dial

(Figure 14, E) to 500. Relock the dial.

A

C

D

E

B