Tv mount wall safe owners manual rev (9/13).
1 index safe information ……………………………………………………………...……………pg. 2 warning standard features installation/mounting …………………………………………………...………………...Pg. 3 set up ………...……………………………………………………...……………………...Pg. 4 opening the door with the key installing the batteries opening the door with the keypad lock out (wr...
2 safe information warning install safe before using. After installing, change the default factory codes. Don’t put emergency key(s) or manual in the safe. Standard features tv mount for tv’s holds up to 65 inches and 80lbs. Maximum vesa of 400 x 400. Hidden storage compartment. Quick drop down acce...
3 included hardware.
4 mounting the wall safe the wall safe can be mounted into a standard residential wall with a depth of at least 7.88 inches and a wall area of at least 22.84 inches (horizontal position) x 26.78 inches (vertical position). Make a hole in the wall that is approximately 14.37 inches x 14.37 inches. Ca...
5 installing the tv mount arm the tv wall safe requires the tv arm to be attached after installation. Locate the tv arm, shaft (k), and two (2) m8x16 button head socket screws (j) in preparation of the installation. Insert the end of the tv arm into the mounting bracket on the safe (as pictured belo...
6 fitting the brackets to the tv installation of the tv brackets may require the use of plastic sleeves (b) if the back of the tv is not flat or the mounting holes are recessed. Locate the tv brackets, m6 flat washers (m), scews (d, e, f, g, h, or i), and plastic sleeves (b). Choosing the scew lengt...
7 mounting the tv to the wall safe caution : you will need installation assistance with these steps. Lift tv onto bracket as shown in diagram 1, making sure it is secure to the top lip of the bracket. Center tv onto the bracket as shown in diagram 2. Tighten set screw to bottom of bracket as show in...
8 setting up the wall safe opening the door with the key in an emergency or electronic failure, the safe can be accessed by using a backup key. The key slot is hidden behind the logo name plate on the front of the safe. Use an allen wrench to unscrew the logo plate. Insert the key into the lock and ...
9 opening the door with the keypad if opening for the first time, the default a ccess codes are ‘1234’ and ‘123456’. Batteries must be installed to work. Enter the current one (1) to eight (8) digit code followed by the (#) button. If the code is correct, the door will open automatically. Note: if t...
10 warranty 1. Cannon security products, llc (the “company”) warrants to the original consumer (the “purchaser’) that this product (the “product”) will be free from defects in workmanship and materials for a period of ninety (90) days from the date of purchase. These warranties are not assignable or...
11 www.Cannonsecurityproducts.Com.
