Cannondale Trigger 27.5/29 Owner's Manual Supplement - page 5
6
7
130728.PDF
T30
Loctite 242 (blue)
10 Nm (88.5 InLbs)
5mm
Loctite 242 (blue)
7 Nm (62 InLbs)
PIVOT AXLE
2.5mm
Loctite 242 (blue)
2.5 Nm ( 22.0 InLbs)
RD HANGER
BRAKE ADAPTER
CAGE MOUNTING BOLTS
Grease
3 Nm (26.5 InLbs)
Cable Clamps
4mm
Loctite 242 (blue)
3 Nm (26.5.5 InLbs)
4mm
Loctite 242 (blue)
4 Nm (35 InLbs)
FD ADAPTER
PIVOT CAP
4mm
Loctite 242 (blue)
3 Nm (26.5.5 InLbs)
SHOCK BOLTS
5mm
Loctite 242 (blue)
8 Nm (71 InLbs)
4mm
Loctite 242 (blue)
5 Nm (44 InLbs)
PIVOT AXLE PINCH BOLTS
PIVOT AXLE
(large end)
SHIM
Loctite 242 (blue)
5 Nm, (44 inLbs)
M5X20
BEARINGS
(small end)
PRELOAD
SCREW
4mm
Loctite 242 (blue)
4 Nm (35 InLbs)
FD ADAPTER
pivot axle removal tool
included in
KP169/
tightening torques
Correct tightening torque for the fasteners (bolts, screws, nuts) on your bicycle is very important to your
safety, the durability and performance of your bicycle. We urge you to have your Dealer correctly torque all
fasteners using a torque wrench. If you decide to tighten fasteners yourself always use a good torque wrench!
EN
main pivot
assemblY steps
Follow these steps to properly install the main pivot
axle:
1. On drive side: tap axle in until in contact with the
frame bearing.
2. Install the shim on non-drive side of the pivot
axle.
3. Position swingarm flush to drive end of axle.
4. Temporarily tighten non-drive pivot clamp bolt.
5. Install the FD adapter and mounting bolt and
tighten it. This will cause the pivot assembly to
align properly.
6. Loosen left pivot clamp.
7. Use preload screw to preload the bearings.
8. Tighten right pivot clamp, 5Nm, (44 inLbs).
9. Tighten left pivot clamp, 5Nm, (44 inLbs).
10. Tighten preload screw, 3 Nm, (26.5 inLbs).
removal
1. Remove the FD adapter from the pivot axle.
2. Remove the preload screw and loosen both
swingarm clamp bolts.
3. Insert KP169/ driver tool into the shim side of
the pivot axle. Carefully drive the pivot out of
both bearings using a rubber mallet.