Chauvet LED Par 64-36VWB User Manual

Summary of LED Par 64-36VWB

  • Page 1

    5200 nw 108th avenue, sunrise, fl 33351 u.S.A. (800) 762-1084 – (954) 577-4455 fax (954) 929-5560 www.Chauvetlighting.Com led par 64-36vwb led par 64-36vwc user manual snapshot use on dimmer outdoor use sound-activated dmx master/slave auto-ranging power supply replaceable fuse user serviceable.

  • Page 2: Able Of

    © copyright 2013 chauvet®. All rights reserved information and specifications in this user manual are subject to change without notice. Chauvet® assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual. T able of c ontents 1. Before you begin.................

  • Page 3: Efore

    Led par 64-36vw b&c user manual 3 rev. 4 1. B efore y ou b egin what is included · 1 x led par 64-36vw b/c · 1 x gel frame · 1 x warranty card · 1 x user manual unpacking instructions immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are p...

  • Page 4: Ntroduction

    Led par 64-36vw b&c user manual 4 rev. 4 safety instructions · please keep this user manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. · always make sure that you are connecting to the proper voltage, and that the line volt...

  • Page 5

    Led par 64-36vw b&c user manual 5 rev. 4 product overview.

  • Page 6

    Led par 64-36vw b&c user manual 6 rev. 4 product overview power output led signal indicator dmx in power input power input (hardwired) microphone audio adjustment knob fuseholder gel frame gel frame release bracket adjustment knob bracket adjustment knob attachment bolt (not meant to be adjusted) dm...

  • Page 7: Etup

    Led par 64-36vw b&c user manual 7 rev. 4 3. S etup ac power this fixture has an auto-ranging power supply which accepts an input of 100~240 vac, 50/60 hz. Before powering on the unit, make sure the line voltage to which you are connecting it is within the range of accepted voltages. Always connect t...

  • Page 8

    Led par 64-36vw b&c user manual 8 rev. 4 do not use a tool on the bracket adjustment knob mounting bracket secondary bracket (used primarily for standing position) aim the fixture with the gel frame release pointing up, (as shown in this diagram) mounting orientation the led par 64-36vw b/c may be m...

  • Page 9: Perating

    Led par 64-36vw b&c user manual 9 rev. 4 4. O perating i nstructions configuring the starting address each fixture requires a starting address from 1~512. A fixture requiring one or more channels for control begins to read the data on the channel indicated by the starting address. For example, a fix...

  • Page 10

    Led par 64-36vw b&c user manual 10 rev. 4 dmx operation this is the operating mode which will allow for control with an external dmx controller. You must set the starting address for this mode. If this is your first time using dmx, then it is recommended that you refer to the “dmx primer” section in...

  • Page 11

    Led par 64-36vw b&c user manual 11 rev. 4 custom static color mixing this fixture has the ability to accept custom static color settings. These are accessed via the control panel. Please see the instructions below for further explanation. 1. Press until u-- appears on the led screen. 2. Press . 3. U...

  • Page 12: Ppendix

    Led par 64-36vw b&c user manual 12 rev. 4 this drawing provides a general illustration of the dmx input/output panel of a lighting fixture. Universal dmx controller continue the link 5. A ppendix fixture linking you will need a serial data link to run light shows of one or more fixtures using a dmx ...

  • Page 13

    Led par 64-36vw b&c user manual 13 rev. 4 general troubleshooting s ymptom p ossible c ause ( s ) p ossible a ction ( s ) breaker/fuse keeps blowing excessive circuit load check total load placed on the electrical circuit. Short circuit along the power wires check for a short in the electrical wirin...

  • Page 14

    Led par 64-36vw b&c user manual 14 rev. 4 return procedure returned merchandise must be sent prepaid and in the original packing; call tags will not be issued. Package must be clearly labeled with a return merchandize authorization number (rma #). Products returned without the rma # will be refused....

  • Page 15

    Led par 64-36vw b&c user manual 15 rev. 4 technical specifications weight & dimensions length ............................................................................................................................................. 10.5 in (266 mm) width ............................................