1. DL manuals
  2. Chauvet
  3. Work Light
  4. LEDsplash 2
  5. User Manual

Chauvet LEDsplash 2 User Manual

Other manuals for LEDsplash 2: Pocket Manual

Summary of LEDsplash 2

  • Page 1

    Snapshot ok on dimmer outdoor ok sound activated dmx512 master/slave autoswitching transformer replaceable fuse user serviceable duty cycle ledsplash ™2 user manual chauvet, 3000 n 29 th ct, hollywood, fl 33020 u.S.A. (800) 762-1084 – (954) 929-1115 fax (954) 929-5560 www.Chauvetlighting.Com.

  • Page 2: Able of

    T able of c ontents 1. Before you begin ................................................................................................................................ 3 w hat is included ..................................................................................................................

  • Page 3: Efore

    1. B efore y ou b egin what is included ¾ 1 x ledsplash™ 2 ¾ power cord ¾ warranty card ¾ user manual unpacking instructions immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify th...

  • Page 4

    Safety instructions please read these instructions carefully, which includes important information about the installation, usage and maintenance of this product. • please keep this user guide for future consultation. If you sell the unit to another user, be sure that they also receive this instructi...

  • Page 5: Ntroduction

    2. I ntroduction features • 6-channel dmx-512 led wash light • blackout/static/dimmer/strobe • static colors and rgb color mixing with or without dmx controller • built-in automated programs via master/slave or dmx • built-in sound activated programs via master/slave or dmx ad d i t i o n a l f e a ...

  • Page 6

    Product overview mounting bracket sound sensitivity knob music/auto switch microphone dipswitches power connector and fuse holder dmx output connector power output (max 8 units) ledsplash 2 only! Dmx input connector ledsplash 2 user manual 6 2008-01-22/09:14.

  • Page 7: Etup

    3. S etup the fuse is located inside this compartment. Remove using a flat head screwdriver. Fuse replacement with a flat head screwdriver wedge the fuse holder out of its housing. Remove the damaged fuse from its holder and replace with exact same type fuse. Insert the fuse holder back in its place...

  • Page 8

    C a b l e c o n n e c t o r s cabling must have a male xlr connector on one end and a female xlr connector on the other end. 2 1 3 output termination reduces signal errors and to avoid signal transmission problems and interference, it is always advisable to connect a dmx signal terminator. 1 3 2 res...

  • Page 9

    Master/slave fixture linking 1. Connect the (male) 3 pin connector side of the dmx cable to the output (female) 3 pin connector of the first fixture. 2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the input connector of the next fixture co...

  • Page 10: Perating

    4. O perating i nstructions operation stand-alone mode (sound-active, auto mode): this mode allows a single unit to run to the beat of the music, or the unit will auto change in auto mode. 1. Set all dipswitches on the unit to the “off” position and the unit will run its built in color change progra...

  • Page 11

    D i p s w i t c h o p t i o n s f unctions d ipswitches ( on ) n otes & d escription color change program none music/auto switch music: sound activated, rotary knob sets sound sensitivity auto: rotary knob sets speed of program 1 low intensity 2 medium intensity red leds 3 full intensity 4 low inten...

  • Page 12

    C hannel v alue f unction c h 2 c h 3 c h 4 c h 5 c h 6 000 Ù 029 rgb control mode red 000 Ù 255 green 000 Ù 255 blue 000 Ù 255 strobe 000 Ù 255 030 Ù 059 060 Ù 119 pulse strobe pulse ( 0 100% ) pulse ( 100 0% ) speed 000 Ù 255 120 Ù 149 color macro color macros see table 1.1 150 Ù 179 r,g,b chase r...

  • Page 13

    General troubleshooting applies to symptom solution(s) lights foggers & snow dimmers & chaser controllers auto shut off check fan thermal switch reset 9 beam is very dim or not bright clean optical system or replace lamp check 220/110v switch for proper setting 9 breaker/fuse keeps blowing check tot...

  • Page 14: Ppendix

    Technical support address: service dept. 3000 n 29th ct, hollywood, fl 33020 (u.S.A.) support (email): tech@chauvetlighting.Com telephone: (954) 929-1115 - (press 4) fax: (954) 929-5560 - (attention: service) website: http://www.Chauvetlighting.Com 5. A ppendix dmx primer there are 512 channels in a...

  • Page 15

    General maintenance to maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance a...

  • Page 16

    Ledsplash 2 user manual 16 2008-01-22/09:14 technical specifications weight & dimensions length............................................................................................................................. 9.5 in (241 mm) width ............................................................