Conair ConairPhone CID110 Owner's Manual

Summary of ConairPhone CID110

  • Page 1

    *you must subscribe to caller id service from your local telephone company to receive caller identification. Hotline 1-800-366-0937 cid110 owner’s manual caller id* telephone with 10-memory dialing nlm055y2 printed in china service center ©2003 conair corporation 7475 n. Glen harbor blvd., glendale,...

  • Page 2

    Important safety instructions when using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sin...

  • Page 3

    To install batteries batteries are required for the caller id functions and telephone operations of the unit. 1. Open the battery door by pulling back the latch. 2. Insert three (3) aa alkaline batteries (not included). 3. Snap the battery door back into place. Note: once batteries are installed, yo...

  • Page 4

    Redial button automatically redials last number called (up to 32 digits). If the number was busy or unanswered: 1. Lift the handset. 2. Press [redial]. Telephone operation receiving a call 1. When your phone rings, pick up the handset and use it like any basic telephone. 2. Hang up the handset to re...

  • Page 5

    If the name and number are not a v a i l a b l e , t h e l c d w i l l s h o w ‘-unavailable-’ with the call’s time and date. The ‘new’ icon turns on and new call led blinks. If no key is pressed within 20 seconds, the lcd will show the ‘answer-ready’ mode, and display the total call counter, new ca...

  • Page 6

    Low battery indication the cid110 will signal you when the batteries become weak and need replacement. Once battery power has been sufficiently drained, the cid110 will appear the battery low icon ( )on the lcd display. Replace the aa batteries with three (3) fresh ones in order to maintain the call...

  • Page 7

    Service according to fcc regulations, this equipment, which has been certified and registered by the fcc, may only be repaired by authorized persons. If repairs or adjustments are made by an unauthorized person, the fcc certification may be voided. Should you encounter any problems, please call the ...