Conair Facial Steamer Instruction Booklet
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be followed,
including the following:
READ ALL
INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER
–
To reduce the risk of electrocution:
1. Always unplug this appliance immediately
after using.
2. Do not use while bathing.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in or drop into water or
other liquid.
5. Do not reach for an appliance that has
fallen into water or other liquid. Unplug
immediately.
WARNING
–
To reduce the
risk of burns, electrocution, fire, or injury to
persons:
1. An appliance should never be left unattended
when plugged in.
2. This product is not to be used by, on, or
near children or by individuals with certain
disabilities.
3. Use this appliance only for its intended
purpose as described in the manual. Do
not use attachments not recommended by
the manufacturer.
4. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, or if it has been dropped, damaged,
or dropped into water. Return the appliance to
a service center for examination and repair.
5. Keep the cord away from heated surfaces.
Do not wrap the cord around the appliance.
6. To avoid burning, do not pick up the unit
while water is hot since water can spill out.
7. Never block the air openings of the
appliance or place it on a soft surface, such
as a bed or couch, where the air openings
may be blocked. Keep the air openings free
of lint, hair, and other debris.
8. Never use while sleeping.
9. Never drop or insert any object into any
opening or hose.
10. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
11. Do not use an extension cord with
this appliance.
12. Unplug this appliance before filling. Fill
reservoir with tap water only. Do not overfill.
13. Use The Microdermabrasion Facial Spa
only on a level surface.
14. Do not use additives.
15. Never place face close to facial steamer
in one position as this may cause scalding.
16. To avoid burning, do not touch after
plugging in water reservoir unit.
17. Do not mix old and new batteries. Do
not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel cadmium) batteries.
18. Do not use the spa without the mask.
19. Do not place hand in the base.
20. Do not touch steam as it comes out of
the base.
21. Do not move or pick up the unit until the
water cools.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This appliance has a polarized plug (one
blade is wider than the other). As a safety
feature, this plug will fit in a polarized outlet
only one way. If the plug does not fit fully in
the outlet, reverse plug. If it still does not fit,
contact a qualified electrician. Do not attempt
to defeat this safety feature.
• The Microdermabrasion unit operates on 2
“AA” batteries. For battery
insertion, gently pull down
lower cap and insert
batteries.
If you have any skin
condition, sensitivity to
heat, or other health issues
or questions, including those relating to use
of this product while undergoing any
treatments or taking any medications, please
consult with a physician before use.
mist begins deep cleansing action.
• Remove your face occasionally and blot
with a cool, damp towel. Steam for a
minimum of 5 minutes, but no longer than
30 minutes.
• Immediately after steaming, rinse your
face with cool water.
INSTRUCTIONS FOR USING
YOUR MICRODERMABRASION
TOOL
• Snap the exfoliating brush attachment
onto the unit, making sure it is securely
attached.
• Apply a generous amount of your favorite
exfoliating cream to your face.
• At the speed of your choice, massage the
cleanser on your face in a circular motion,
making sure not to exceed two minutes.
• Use for 10 second intervals per area
beginning with the forehead; avoiding the
eye area, move downwards toward the
cheek and nose area then to your chin area.
This step exfoliates, thoroughly cleans and
removes dulled skin cells. Rinse face and
pat dry. Next apply cool water or your
favorite astringent to close pores and seal
in moisture.
• Now you are ready to apply your favorite
moisturizing lotion by using the sponge
applicator. Dot your forehead, cheeks, nose
and chin with a generous amount of mois-
turizer and smooth the cream into your
skin. Apply light to medium pressure and
use upward, circular strokes. After just one
personal facial with the Microdermabrasion
Facial Spa you’ll find your skin looking
fresher and healthier.
This product should not be used in the
following cases:
Tuberculosis, benign and malignant tumors,
inflammations of the skin, phlebitis and
thrombosis, open and fresh wounds, bruises,
broken skin or varicose veins.
INSTRUCTIONS FOR USING
YOUR MICRODERMABRASION
SPA
Before beginning, cleanse your face, following
your daily care routine. Lightly pat your
favorite moisturizer or eye cream around the
eye area.
USING YOUR FACIAL
STEAMING UNIT
• Your Facial Spa includes two detachable
cones:
1. Facial Mask: Use for facial cleaning.
2. Sinus Cone: Use for concentrated
steam to assist in respiratory therapy.
Place your nose in the sinus cone with
forehead touching curved rim. Relax as
soothing mist promotes easier breathing,
however, do not use as room humidifier.
• Turn facial mask or sinus cone counter-
clockwise and lift away
from base.
• Fill the water cylinder
with warm tap water. Pour
water into the reservoir
and plug it into a 120 volt
AC household outlet. (See
Figure 1)
Figure 1
• Place facial mask or
sinus cone over unit. Lock
by aligning bumps on
facial mask with slots
over water reservoir and
turn clockwise. (See
Figure 2)
• Press “ON/OFF” button to turn unit on.
• When the power is on, the ready indicator
light will flash for 3 minutes as the water is
preheating.
• When the indicator light has stopped
flashing and is steady, you may use the
Facial Spa. Unit will automatically shut off
after 45 minutes.
• FOR A TIMED TREATMENT, the timer
control can be set from 3 to 15 minutes by
rotating the knob to desired time.
• Press the timer start button and the timer
indicator light will go on.
• The unit will shut off and a buzzer will
sound to indicate that preset time has expired.
NOTE: One fill provides between 10-30
minutes of soothing mist. If the facial spa
should run out of water, shut off
immediately, then begin your facial again.
• Clean your face and neck
• Allow approximately 3 to 4 minutes for
steam mist to develop, then place your face
gently against the rim of the facial mask or
sinus cone. To avoid burning, do not pick
up the unit while water is hot since water
will spill out.
• If more steam is desired, place a towel
over your head that so it covers the mask
and sides of the steamer.
• Close your eyes and relax as the soothing
Figure 2
03PC2407 MDF2 IB 8/19/03 10:05 AM Page 1