Conair Relaxation Fountain Instruction Book

IMPORTANT SAFETY INSTRUCTIONS

Read all instructions before using the Conair Relaxation Fountain.

DANGER–

 To reduce the risk of electric shock:

1.  Do not remove cord and strain relief. Do not connect conduit to pump.

2.  Always unplug the product from the electrical outlet immediately after using and 

before cleaning.

3.  If  the  product  shows  any  sign  of  abnormal  water  leakage,  immediately  unplug  from  the  

power source.

4.  Carefully examine the device after installation. If there is water on any parts that should not  

get wet, device should be unplugged.

5.  To avoid possibility of the plug or wall outlet getting wet, make sure the cord dips bellow  

the outlet

WARNING– 

To reduce the risk of burns, electrocution, fire, or injury to persons:

OPERATE YOUR SYSTEM ACCORDING TO THIS MANUAL.

1.  Unplug your Relaxation Fountain from outlet when not in use, and before putting on or taking 

off parts.

2.  Use this product only for its intended use as described in this manual. Do not use 

attachments not recommended by the manufacturer.

3.  Never operate the Relaxation Fountain if it has a damaged cord or plug, if it is not working 

properly, or if it has been dropped or damaged in any manner. Contact your dealer for 

instructions on returning it for examination and repair.

4.  Close supervision is necessary when this product is used by or near children and 

disabled persons.

5.  The pump has been evaluated for use with water only.

6.  For INDOOR USE ONLY.

7.  Do not use with water above 30°C.

8.  Do not let pump run dry as damage to pump may result.

MAINTENANCE INSTRUCTIONS:

1.  No user maintenance of this product is required. If the system does not function, be sure the  

CORD is plugged into and fully engaged in the electrical outlet.

2.  If there is a malfunction of any kind, contact your dealer for instructions on returning it for  

examination and repair.

3.  Never pull on the pump cord. Never twist or wrap cord around the pump; lay it flat with cord  

coiled up when not in use. 

4.  Clean the water intake holes before storage of Relaxation Fountain.

SAVE THESE INSTRUCTIONS

HOW TO OPERATE YOUR  

RELAxATION FOUNTAIN

RELAxATION FOUNTAIN INCLUDES:

• 1 fountain bowl

• 1 adjustable pump with tube

• 1 large assembly with light

• 1 Assortment of stones

• 1 ball

ASSEMBLY INSTRUCTIONS:

1.  Carefully remove contents from the box.

2.  Put the pump in the bottom of the bowl. Secure the pump through suction cup by pushing the 

pump downward. Place the plastic tube vertically into hole in the pump. Pump tube should be 

in the middle of the bowl. Be sure to keep the plug end dry at all times.

3.  Add enough water so that the pump is submerged. Add water to the water-fill mark in the 

bowl. DO NOT OVERFILL, as splashing may occur.

4.  Plug the cord into electrical outlet. Wait a few moments for water to flow through the bowl to 

small mounting pods.

5.  If water flow is too fast or slow, unplug and adjust the speed of the water pump by turning the 

adjustable knob located on the side of the pump marked MAX or MIN.

6.  Be careful, since water may splash even at low pump speeds. The water may damage furni-

ture.

7.  Dirt may clog the intake screen of the pump. Clear regularly to maintain pump performance. 

Rinse unplugged pump under clean water, and remove debris with small brush.

8.  Change water regularly.

WARNING: IF YOU THINK THE POWER IS OFF WHEN THE SWITCH IS 

OFF, YOU’RE WRONG.

Everyone knows that electricity and water are a dangerous combination. But did you know that an 

electric appliance is still electrically alive even if the switch is off? If the plug is in, the power is on. 

So when you are not using your appliances, keep them unplugged.

Fountain bowl

Adjustable 

pump with tube

Ball

Large assembly 

with light

Assortment of 

stones