Conair TGBE4RC Manual
IMPORTANT SAFETY
INSTRUCTIONS
THIS APPLIANCE IS INTENDED FOR HOUSEHOLD
USE. WHEN USING ELECTRICAL APPLIANCES, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE TAKEN,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS
BEFORE USING THIS
MIRROR
DANGER
–
TO REDUCE THE RISK OF
ELECTRIC SHOCK: ALWAYS UNPLUG THIS FURNISHING
FROM THE ELECTRICAL OUTLET BEFORE CLEANING
WARNING
–
TO REDUCE THE RISK
OF BURNS, ELECTROCUTION, FIRE, OR INjURY TO
PERSONS:
1.
Read all instructions before using the
appliance.
2. To protect against electrical hazards, do not use
while bathing or in the shower.
3. Close supervision is necessary when any appliance
is used by or near children or by invalids.
4. Unplug the appliance from outlet when not in
use and before cleaning. Do not leave appliance
unattended when it is plugged in. Keep cord away
from heated surfaces.
5. Do not operate this appliance with a damaged
cord or plug or if the appliance malfunctions or
has been dropped or damaged in any manner.
Return appliance to nearest service facility for
examination, electrical or mechanical adjustment,
or repair. No repairs should be attempted by the
consumer.
6. Use appliance only for intended use as described
in this instruction book. The use of attachments
not recommended or sold by Conair may cause
hazards.
7. Do not use outdoors or operate where aerosol
(spray) products are being used, or where oxygen
is being administered.
8. Be sure mirror is not in a position where it can
reflect sunlight; reflected sunlight can cause fire.
9. Do not use on a soft surface such as a bed, where
openings may be blocked.
10. Turn switch to “OFF” position and unplug cord
before replacing light bulbs.
11.Do not place or store appliance where it can fall or
be pulled into a tub or sink.
12.Do not place in or drop into water or other liquid.
13. If an appliance falls into water, unplug it immediately.
Do not reach into the water.
Use on any 120 volt 60 hertz AC electric outlet
(ordinary house current). Do not use it on any other
electrical outlet.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
1. Your lighted makeup mirror is 5.5 in. diameter
with 5X and 1X magnification. (Fig. 1)
2. This unit operates on 3 “AA” batteries (not
included) or an adapter (included). Plug into any
standard wall outlet (120 Volt AC). Turn switch to
the “ON” position.
3. After use, always turn switch to the “OFF”
position and unplug the adapter from the wall
outlet.
4. The beauty and design of this mirror complement
any decor. Therefore, you may wish to leave
the mirror displayed. However, if you choose
to store the mirror, see “STORAGE” for detailed
information.
5. Use only new batteries. DO NOT MIX old and new
batteries. DO NOT MIX alkaline, standard (carbon-
zinc) or rechargeable (nickel cadmium) batteries
.
A.C. ADAPTER
NOTE: unit supplied with a UL listed 3.6VAC adapter.
For more information, please contact a conair
service center.
TO REPLACE BULB
CAUTION: TURN OFF POWER AND UNPLUG. ALLOW
TO COOL AT LEAST 3 MINUTES BEFORE REPLACING
BULB.
NOTE: Do not use bulbs other than those supplied
by Conair. Contact a Conair service center for
replacement bulb information.
1. Unscrew the two side screws on the mirror head.
2. Carefully remove the 5X Magnification mirror head
housing.
3. Unscrew light bulbs and replace with new light
INSIDE VIEW
(Fig. 1)
(Fig. 2)
bulb.
4. Replace mirror head by lining up the screw holes
and screw into place.
TO INSTALL BATTERIES
1. Remove battery cover.
2. Install 3 “AA” new batteries as indicated on battery
box. (Fig. 2)
3. Replace battery cover by snapping it into place.
MAINTENANCE
Your lighted mirror is designed for household use and is
virtually maintenance-free. No lubrication is needed.
If cleaning becomes necessary, disconnect the appli-
ance from the power source and wipe exterior with a
damp cloth. Clean mirror surfaces with a glass cleaner.
Do not light until you are certain mirror is completely
dry.
If any abnormal condition occurs, unplug the lighted
mirror, allow it to cool, and return it to an authorized
service center for repair.
Bottom Cover
Unscrew for
bulb access