Conairphone TAD2012 Owner's Manual - Remote Operation (Cont.)
IMPORTANT
Remote message retrieval will not work
when calling from a rotary or push
button pulse dialing phone, unless a tone
generator is used.
Also, some touch tone phones only
output tones for a fraction of a second.
If you experience difficulty with remote
operation, try another phone, or use a
separate tone generator.
11
Remote Operation (Cont.)
Troubleshooting Guide
DON'T RETURN IT YET!
To Retrieve Messages When Recording
Memory Is Full
1. When the message capacity is full, the
unit will sound 3 beeps after answering
the phone.
2. Within 10 seconds after the 3 beeps,
dial your 3 digit security code.
3. Your unit will emit 4 short beep tones
once correct code is detected and
playback all incoming messages.
If you have followed the instructions in
this manual, and have difficulty operating
your CallKeeper Answering System,
locate the PROBLEM in the left column
below. Check the corresponding
POSSIBLE CAUSE and CORRECTIVE
ACTION columns to locate and remedy
problem.
If the solution to your problem is not
listed below, call our toll-free service
number 1-800-366-0937 and one of our
experts will talk you through the problem.
R
PROBLEM
Unit is not
operating
properly.
My message
indicator
won't stop
flashing.
No answer
POSSIBLE CAUSE
Power failure
Various
Unit is in the "OFF" mode
CORRECTIVE ACTION
Proceed with a unit reset (see p. 9)
Refer to Understanding Your Message
Indicator (see p. 7)
Check to verify if message counter is lit.
Press Answer ON/OFF control to turn unit on.