- DL manuals
- CONCORD
- Fan
- Calavera 52CAL
- Owner's Manual
CONCORD Calavera 52CAL Owner's Manual
Summary of Calavera 52CAL
Page 1
A commitment to excellence calavera ™ owners manual and installation instructions ® 52cal (revised 05.01.07).
Page 2
2 read and save these instructions before beginning installation of your new concord ® ceiling fan, read and follow these safety precautions. If you are not familiar with national and local electrical codes and basic electrical wiring procedures, we recommend that you have a qualified electrician in...
Page 3
3 this ceiling fan was not designed for installation in any location where it might be exposed to moisture or high humidity. Installation in this type of location could be unsafe, will most likely damage the fan and its finish... And will void your warranty. Every effort has been made to provide you...
Page 4
4 fig. 1 have you turned off the electricity? Loosen the two canopy mounting screws on the downside face of the mounting bracket. Back them out about half way. This will allow for easier installation of the ceiling canopy later (see figure 1). Install the mounting bracket on the electrical junction ...
Page 5
5 loosen the set screws (2) in the support rod cou- pler located on the top center of the motor hous- ing (see figure 6) until the inside channel is clear. Remove and save the safety screw from the cou- pler. Place coupler cover over the support rod cover. Place rubber canopy ring over the coupler c...
Page 6
6 notice the half ball on the end of the support rod is grooved down one side. This keyway fits over the small keyway pin on the inside of the mounting bracket and keeps the ceiling fan from spinning on the mounting bracket. Using your step ladder, lift the fan and place the half ball in the center ...
Page 7
7 fig. 11 fig. 12 slide the ceiling canopy up into place over the ceiling mounting bracket. Slide rubber canopy cover into place. The two screws on the mount- ing bracket face should slip through the key hole slots in the canopy (see figure 11). Step 7 attaching the ceiling canopy, depending on how ...
Page 8
8 fig. 13 fig. 14 remove the large screws in the face of the motor. Discard any rubber blocks attached to these screws. The rubber blocks are installed at the factory to stabilize the motor during ship- ment. Attach each blade to the motor face using the two screws attached to the blade arm (see fig...
Page 9
9 fig. 16 back off (loosen) the three screws on the electri- cal housing mounting plate attached to the motor shaft (see figure 14). Remove the center cap on switch housing by pushing on the inside of switch housing. Feed wires from fixture through center hole on switch housing. Thread nipple on top...
Page 10
10 slide shade over the socket and secure with socket ring. Install light bulb (included) into socket. Step 11 shade and bulb installation check all safety pins, set screws and connec- tions are properly in place and tight. Check blade clearance and rotation. Attach the decorative pull chain tassel(...
Page 11: Optional Wiring Diagrams
11 figure 18 illustrates the wiring used to control the fan with a wall switch plus an optional light fixture controlled at the fixture. Figure 19 illustrates the wiring used to control fan with the pull chain on the electrical switch housing plus an optional light fixture with a wall switch. Figure...
Page 12: Operation Instructions
12 © great 2000 enterprises, inc., 2007 • all rights reserved • no part of this publication may be produced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of great 2000 enterprises, inc.. Concord fans a...